EN-Labs 11-001-366 PCIe x4 USB 3.2 10Gbps 5-port card
- no
- 12CM Case fan,screw…
نقبل الدفع بالعملة المشفرة — لذلك يمكن للعملات الرقمية التي تملكها أن تشتري أجهزة حقيقية.ادفع بالعملة المشفرة، وأنفقها على أجهزة حقيقية. شحن مؤمن مجانا إلى كل أنحاء العالم لما يتجاوز 399 US$. صناديق شحن بسيطة بلا علامة تجارية، ترسل من ألمانيا.شحن مؤمن مجانا لما يتجاوز 399 US$. يُقفل سعرك لمدة 30 دقيقة بمجرد فتح صفحة الدفع.السعر مقفل لمدة 30 دقيقة. كل قطعة مختومة، ورقمها التسلسلي متحقق منه، ومشمولة بضمان 24 شهرا.مختوم، وبضمان 24 شهرا.
OWC
8GB DDR4 2400 ECC registered RDIMM for servers and workstations, CL17 at 1.2V
This 8 GB DDR4 2400 module is built for servers, workstations and NAS systems that require ECC registered memory. It will not work in standard desktop computers and cannot be mixed with unbuffered modules. The 288-pin RDIMM matches the Samsung M393A1K43BB0-CRC specification exactly.
Operating at 1.2 V with a CL17 latency, the module draws minimal power and generates little heat without a spreader. Registered buffering reduces electrical load on the memory controller, helping keep system thermals stable during continuous workloads. Silent solid-state operation adds no audible noise to the chassis.
The stick fits any 288-pin DDR4 RDIMM slot that supports PC4-19200 speeds and registered ECC. It frees a standard DIMM slot for additional registered modules of the same type. Builders needing unbuffered memory, desktop compatibility or higher capacities must choose different modules.
| Brand | OWC |
|---|---|
| Part Number | 2R4D41R808GB |
| Capacity | 8GB |
| Type | 288-Pin DDR4 ECC RDIMM |
| Speed | DDR4 2400 (PC4 19200) |
| CAS Latency | CL17 |
| Voltage | 1.2V |
| ECC | Yes |
| Buffered/Registered | Registered |
| Rank | 1Rx8 |
| Heat Spreader | No |
Power down the server, open the chassis, align the notch on the 288-Pin module with the slot key, press firmly until both clips lock, then verify in BIOS that ECC Registered mode is active — skipping the BIOS check is the common oversight.
No scheduled maintenance is required; the module has no heat spreader and runs at 1.2V, so replacement only occurs if a memory test reports correctable ECC errors rising above threshold or if capacity must be increased.
The CL17 latency at 2400 MT/s sets the throughput ceiling; sustained use will hit bandwidth limits before thermal throttling because the module operates at standard 1.2V without a spreader.
أيضًا في هذا القسم
نفس القسم، ونفس صفحة الدفع — ثماني عملات رقمية وقفل سعر لمدة 30 دقيقة.
ما تدفعه، وما تُعرض به الأسعار.
يُرسَل من محفظتك عند إتمام الطلب
للعرض فقط — أسعار الكتالوج بالدولار الأمريكي
لا توجد عملة مطابقة.
اختر اللغة التي يخاطبك بها الموقع.
لا توجد لغة مطابقة.
هل أنت جديد هنا؟
لديك حساب بالفعل؟
لا توجد إعادة تعيين تلقائية: هذا المتجر لا يُرسل أي بريد، فلا يوجد رابط لمرة واحدة يمكن طلبه. اترك العنوان في الحساب، وسيُعالَج الأمر يدويًا.
تم تسجيل الطلب
لا شيء في طريقه إلى بريدك الوارد — هذا المتجر لا يُرسل أي بريد إطلاقًا. يتولّى أحدهم معالجة هذه الطلبات يدويًا.
تذكّرتها؟