OEM Industries
OEM Industries KF0410B2H-R 40mm 24V 1.2W 2-pin fan
40 mm ball-bearing fan runs on 24 V and draws 1.2 W for compact server or inverter cooling
- ColorBlack
- TypeFan only
- Fan Size40mm
- Bearing TypeBall
- Power Connector2 Pin
- LEDNo
- Compact 40 mm footprint fits tight server bays
- Ball bearing ensures long service life
- 24 V 1.2 W draw keeps power budget low
- Two-pin connector simplifies wiring
- No LED avoids unwanted light in racks
Jamicon 40mm micro server fan
The Jamicon KF0410B2H-R is a 40 by 10 millimetre axial fan built for 24 volt server and inverter chassis. It draws 1.2 watts through a two pin connector and uses a ball bearing for continuous duty in compact rack environments.
Replaces noisy 40mm sleeve bearing fans
Swapping a worn sleeve bearing unit for this ball bearing model removes rattling and extends service life in always on infrastructure. The upgrade is worth it when the existing fan develops vibration or fails to spin at full speed under load.
Two pin plug fits standard headers
Installation requires matching the red and black leads to the board header; reversing polarity will stop the motor. The 10 millimetre thickness fits most 40mm mounts but verify clearance against tall heatsinks or cable looms before securing the screws.
Акценти
- Compact 40 mm footprint fits tight server bays
- Ball bearing ensures long service life
- 24 V 1.2 W draw keeps power budget low
- Two-pin connector simplifies wiring
- No LED avoids unwanted light in racks
Спецификации
| Model | KF0410B2H-R |
|---|---|
| Color | Black |
| Type | Fan only |
| Fan Size | 40mm |
| Bearing Type | Ball |
| Power Connector | 2 Pin |
| LED | No |
Въпроси за този артикул
Will the 40 mm by 10 mm frame fit my server cooler slot?
The fan measures 40 mm square and 10 mm thick, so it fits any standard 40 mm mounting pattern.
How do I connect the 2-pin 24 V lead without reversing polarity?
Align the red wire to the positive pin and the black wire to the negative pin on the 2-pin header; the connector is keyed to prevent reverse insertion.
When should I plan to replace the ball-bearing fan?
Ball bearings typically run for tens of thousands of hours; replace the fan if noise increases or airflow drops noticeably.
Още от този рафт
Често сравнявани заедно
Същият рафт, същата каса — осем монети и заключване на курса за 30 минути.
ModMyMods MOD-0002 3/8" ID x 1/2" OD Clear PVC Tubing DIY Cooling
- Clear



