Přijímáme kryptoměny — takže to, co držíte, můžete utratit za skutečný hardware.Plaťte kryptem, utrácejte ho za skutečný hardware. Pojištěná doprava zdarma po celém světě nad 399 $. Neutrální přepravní krabice bez loga, odesílané z Německa.Pojištěná doprava zdarma nad 399 $. Jakmile se otevře pokladna, je váš kurz zablokovaný na 30 minut.Kurz zablokovaný na 30 minut. Každý výrobek je zapečetěný, jeho sériové číslo je zkontrolované a vztahuje se na něj 24měsíční záruka.Zapečetěno, záruka 24 měsíců.

Sledované položky Přihlásit se
Green circuit board with black memory chips, no heat spreader, 240-pin DDR3 DIMM

Computer Memory Solutions

Computer Memory Solutions CM10247210600ECCNR2R8 8GB DDR3 1333 ECC Unregistered DIMM memory upgrade

SKU CH-S5P7-TPX92

8GB DDR3 1333 ECC unregistered DIMM validated for Supermicro X9SCL and B9DRE server motherboards

  • Capacity8GB
  • Type240-Pin DDR3 SDRAM
  • SpeedDDR3 1333 (PC3 10600)
  • CAS LatencyCL9
  • Timing9-9-9
  • Voltage1.5V
  • 8GB capacity supports up to 32GB total system memory
  • ECC protection detects and corrects single-bit data errors
  • DDR3 1333 MHz speed matches PC3-10600 specification
  • Unregistered 240-pin DIMM fits Supermicro X9SCL and B9DRE boards
  • 5V operation reduces power draw and heat output

8GB DDR3 ECC DIMM for Supermicro servers

This 8GB DDR3 1333 module adds error-correcting memory to Supermicro X9SCL and B9DRE motherboards. It is built as a single unregistered DIMM for systems that require ECC without registered buffering. The kit contains one stick to fill an available slot. It targets administrators upgrading compatible server boards.

240-pin unregistered layout fits four-slot boards

The module uses a standard 240-pin DDR3 edge connector with no heat spreader. Unregistered signalling keeps the electrical load light on the memory controller. Four DIMM sockets on the supported boards allow a maximum of 32GB when all slots are populated. Major-brand DRAM chips are used throughout.

1.5V operation at CL9 9-9-9 timing

Rated at 1.5 volts, the stick runs at the standard DDR3 voltage for low power draw. CAS latency of nine cycles at 1333 MHz delivers predictable access times. No active cooling is required on the bare PCB. The module operates within normal server thermal limits.

Přednosti

  • 8GB capacity supports up to 32GB total system memory
  • ECC protection detects and corrects single-bit data errors
  • DDR3 1333 MHz speed matches PC3-10600 specification
  • Unregistered 240-pin DIMM fits Supermicro X9SCL and B9DRE boards
  • 5V operation reduces power draw and heat output

Specifikace

BrandComputer Memory Solutions
ModelCM10247210600ECCNR2R8
Capacity8GB
Type240-Pin DDR3 SDRAM
SpeedDDR3 1333 (PC3 10600)
CAS LatencyCL9
Timing9-9-9
Voltage1.5V
ECCYes
Buffered/RegisteredUnregistered
Rank2Rx8
ChipsetMajor Brand Chipset
Heat SpreaderNo
Compatible SystemSupermicro MBd-X9Scl-F-B, X9Scl-F, B9Dre Motherboard
Package Content1Memory Ram Stick

Otázky k tomuto produktu

What speed does the DDR3 1333 PC3-10600 interface run at in practice?

The module operates at 1333 MHz with a PC3-10600 data rate and CL9 9-9-9 timings at 1.5V.

Will this 240-pin DDR3 DIMM fit the four slots on my Supermicro X9SCL-F motherboard?

Yes, the 240-pin unregistered ECC DIMM matches the four DDR3 slots on the X9SCL-F, X9SCL-F-B and B9DRE boards supporting up to 32 GB total.

How do I install this CMS 8 GB stick and what step do people often miss?

Power off the server, open the chassis, align the notch on the 240-pin edge connector, press firmly until both retention clips click, then verify the full 8 GB appears in BIOS.

Také v této kategorii

Zákazníci také porovnávali

Stejná kategorie, stejná pokladna — osm měn a kurz zamčený na 30 minut.