myVolts Regulated DC Power Supply 0-30V 0-10A

Compact bench supply for labs and repair

This myVolts regulated DC power supply delivers adjustable output from 0 to 30 V and 0 to 10 A for prototyping, service benches and classroom work. The four‑digit LED display shows voltage and current simultaneously so you can set limits at a glance. Rugged metal housing makes it suited to daily use in manufacturing, university labs and appliance repair shops. It runs from a 220 V AC mains input at 50 Hz.

Thermal and noise profile at typical settings

Forced‑air cooling keeps internal temperatures in check while the unit operates within the rated 0 to 40 °C ambient range. Fan noise remains low enough for bench‑side conversation during normal voltage and current levels. Power draw follows the load, so idle consumption is minimal and efficiency stays high across the working range. The metal chassis also acts as a heatsink, spreading warmth without hotspots.

Behaviour under continuous load

The supply maintains stable regulation during extended runs thanks to built‑in over‑voltage and over‑current protection that clamps transients without shutdown. Accuracy is specified at 23 ± 5 °C, so prolonged operation near full output stays within tolerance if ambient conditions are met. Ventilation gaps of at least 10 cm are recommended to sustain airflow during long sessions. Storage extremes of -20 to 60 °C do not affect calibration once the unit returns to normal conditions.