NEMIX RAM DDR5-5600 2TB (16x128GB) ECC RDIMM CL46 1.1V Supermicro H14SST-G memory upgrade
- 2TB (16 x 128GB)
- 288-Pin DDR5 RDIMM
Přijímáme kryptoměny — takže to, co držíte, můžete utratit za skutečný hardware.Plaťte kryptem, utrácejte ho za skutečný hardware. Pojištěná doprava zdarma po celém světě nad 399 $. Neutrální přepravní krabice bez loga, odesílané z Německa.Pojištěná doprava zdarma nad 399 $. Jakmile se otevře pokladna, je váš kurz zablokovaný na 30 minut.Kurz zablokovaný na 30 minut. Každý výrobek je zapečetěný, jeho sériové číslo je zkontrolované a vztahuje se na něj 24měsíční záruka.Zapečetěno, záruka 24 měsíců.
myVolts
A 240 W aluminium-cased switch-mode unit delivering 24 V at 10 A with short-circuit, overload and over-voltage protection, CCC, FCC and CE compliance, and 100 % full-load burn-in testing
This aluminium alloy switch-mode unit delivers 240 watts at 24 volts with a 10 amp output. It accepts AC input from 110 to 220 volts with a fifteen percent tolerance. The supply is built for industrial automation, LED displays, CCTV, radio, computer engineering, LED light bars and 3D printers.
The driver is rated for continuous operation at one hundred percent load after a full burn-in test. Protection circuits guard against short circuit, overload and overvoltage conditions. High working efficiency and low DC ripple keep output stable during extended use. The unit operates in ambient temperatures from zero to forty degrees Celsius.
Natural convection cooling eliminates fan noise entirely. The aluminium alloy chassis acts as a heatsink while maintaining excellent insulation strength. Storage temperature range spans minus twenty to sixty degrees Celsius. Humidity tolerance reaches ninety-five percent non-condensing.
| Type | AT |
|---|
It uses natural convection cooling with no fan, so it runs silently. The aluminium alloy case dissipates heat while the unit stays within the 0–40 °C working temperature range.
You need an AC mains cable for the L and N terminals and your load wiring for the V+ and GND terminals. A small screwdriver is required for the screw terminals.
Yes. The output is a steady 24 V DC with overload, over-voltage and short-circuit protection, so legacy devices drawing less than the 10 A rating are protected.
Také v této kategorii
Stejná kategorie, stejná pokladna — osm měn a kurz zamčený na 30 minut.
Měna, ve které platíte, a měna, ve které se zobrazují ceny.
Odesláno z vaší peněženky u pokladny
Pouze pro zobrazení — katalog je veden v dolarech
Žádná měna neodpovídá.
Vyberte jazyk, ve kterém s vámi bude web komunikovat.
Poprvé tady?
Už účet máte?
Neexistuje žádná automatická obnova hesla: tento obchod neposílá žádné e-maily, takže neexistuje jednorázový odkaz, o který by bylo možné požádat. Nechte adresu uvedenou u účtu, vyřídíme ji ručně.
Žádost zaznamenána
Do vaší schránky nic nedorazí — tento obchod neposílá žádné e-maily. Někdo se o to postará ručně.
Vzpomněli jste si?