Přijímáme kryptoměny — takže to, co držíte, můžete utratit za skutečný hardware.Plaťte kryptem, utrácejte ho za skutečný hardware. Pojištěná doprava zdarma po celém světě nad 399 $. Neutrální přepravní krabice bez loga, odesílané z Německa.Pojištěná doprava zdarma nad 399 $. Jakmile se otevře pokladna, je váš kurz zablokovaný na 30 minut.Kurz zablokovaný na 30 minut. Každý výrobek je zapečetěný, jeho sériové číslo je zkontrolované a vztahuje se na něj 24měsíční záruka.Zapečetěno, záruka 24 měsíců.

Sledované položky Přihlásit se
Four green 288-pin DDR5 RDIMM modules in static bags

NEMIX RAM

NEMIX RAM 256GB (4×64GB) DDR5 4800 ECC RDIMM CL40 1.1V 2Rx4 Supermicro H14SSL-NT

SKU CH-HECK-Q25VW

A 256 GB DDR5 ECC registered RDIMM kit of four 64 GB modules running at 4800 MHz CL40 1.1 V for the Supermicro H14SSL-NT motherboard

  • Capacity256GB (4 x 64GB)
  • Type288-Pin DDR5 RDIMM
  • SpeedDDR5 4800 (PC5 38400)
  • CAS LatencyCL40
  • Voltage1.10V
  • ECCYes

Size 256GB 4X64GB

Zobrazit dalších 24 konfigurací
  • 256GB kit fills four slots for maximum server capacity
  • DDR5 4800 CL40 matches the motherboard's rated speed and timing
  • ECC and registered design corrects errors and stabilises fully populated channels
  • 1V operation reduces power draw per module
  • Samsung Micron Hynix chips provide enterprise-grade component quality

Exact-match DDR5-4800 ECC RDIMM kit

This NEMIX RAM kit supplies 256GB across four 64GB modules built to the DDR5-4800 (PC5-38400) JEDEC standard with CL40 latency and 1.10V operation. Each 288-pin Registered DIMM uses a 2Rx4 organization with on-die ECC, matching the Supermicro H14SSL-NT motherboard's memory-controller expectations for full-capacity recognition at rated speed. It is not intended for consumer desktop boards that require unbuffered UDIMMs or lower-density modules.

Sustained-load stability under full population

Registered buffering offloads the memory controller so all four slots can run fully populated at the rated 4800MT/s without down-clocking, while ECC corrects single-bit errors on the fly to prevent silent data corruption during long compute runs. The 1.10V JEDEC voltage keeps power draw predictable across continuous workloads. Buyers who need higher transfer rates or lower CAS latencies than the DDR5-4800 CL40 specification will not find them in this kit.

Straightforward server installation

The 288-pin RDIMM form factor seats directly into the H14SSL-NT DIMM slots; no heat spreaders are present, so clearance is minimal. Because server memory population order is board-specific, the system manual must be consulted for the approved slot sequence before installation — incorrect ordering is the most common cause of a no-post condition. Mixing these modules with different ranks, voltages, or speeds is not supported.

Přednosti

  • 256GB kit fills four slots for maximum server capacity
  • DDR5 4800 CL40 matches the motherboard's rated speed and timing
  • ECC and registered design corrects errors and stabilises fully populated channels
  • 1V operation reduces power draw per module
  • Samsung Micron Hynix chips provide enterprise-grade component quality

Specifikace

BrandNEMIX RAM
SeriesNEMIX RAM Original Series Server Memory
ModelDDR5 ECC RDIMM Registered Server Memory
Part NumberMR38400-924K4
Capacity256GB (4 x 64GB)
Type288-Pin DDR5 RDIMM
SpeedDDR5 4800 (PC5 38400)
CAS LatencyCL40
Voltage1.10V
ECCYes
Buffered/RegisteredRegistered
Rank2Rx4
ChipsetMajor OEM Samsung, Micron, Hynix
Heat SpreaderNo
Compatible SystemSupermicro
FeaturesDDR5 ECC RDIMM Motherboard Compatible
Package Content256GB 4X64GB DDR5 4800MHz PC5-38400 2Rx4 1.1V 288-PIN ECC RDIMM KIT

Další verze tohoto modelu

Dalších 5 v této řadě

Stejná řada, jiná paměť, chladič nebo takt — porovnejte, než se rozhodnete.

Otázky k tomuto produktu

How much power do four 1.10 V DDR5-4800 2Rx4 RDIMMs draw under sustained load?

Each module runs at 1.10 V and DDR5-4800 speed; total power depends on workload and the Supermicro H14SSL-NT memory controller, but registered architecture offloads the controller so all four slots can stay fully populated at rated speed.

What motherboard slot type and memory population rules does this kit require?

The kit uses 288-pin DDR5 RDIMM form factor and is verified for the Supermicro H14SSL-NT; consult that board's manual for supported capacities and the approved DIMM installation order.

Will these CL40 2Rx4 registered ECC RDIMMs run at DDR5-4800 alongside slower DDR5 modules already installed in the same server?

The memory controller typically clocks all populated slots to the lowest common speed, so mixing with slower DDR5 RDIMMs would drop the kit from its rated 4800 MT/s to the slower module's speed.

Také v této kategorii

Zákazníci také porovnávali

Stejná kategorie, stejná pokladna — osm měn a kurz zamčený na 30 minut.