Přijímáme kryptoměny — takže to, co držíte, můžete utratit za skutečný hardware.Plaťte kryptem, utrácejte ho za skutečný hardware. Pojištěná doprava zdarma po celém světě nad 399 $. Neutrální přepravní krabice bez loga, odesílané z Německa.Pojištěná doprava zdarma nad 399 $. Jakmile se otevře pokladna, je váš kurz zablokovaný na 30 minut.Kurz zablokovaný na 30 minut. Každý výrobek je zapečetěný, jeho sériové číslo je zkontrolované a vztahuje se na něj 24měsíční záruka.Zapečetěno, záruka 24 měsíců.

Sledované položky Přihlásit se
Twelve green DDR5 RDIMM modules in a row

NEMIX RAM

NEMIX RAM 384GB (12x32GB) DDR5 4800 CL40 2Rx8 ECC RDIMM Supermicro H14DSH memory upgrade

SKU CH-8RVD-XAQ97

A 384GB kit of twelve 32GB DDR5-4800 ECC registered RDIMMs built for the Supermicro H14DSH motherboard

  • Capacity384GB (12 x 32GB)
  • Type288-Pin DDR5 RDIMM
  • SpeedDDR5 4800 (PC5 38400)
  • CAS LatencyCL40
  • Voltage1.10V
  • ECCYes

Size 384GB 12X32GB

Zobrazit dalších 30 konfigurací
  • 384 GB total capacity across 12 modules of 32 GB each
  • DDR5 4800 speed with CL40 latency runs at rated frequency
  • Registered ECC design offloads controller and corrects single-bit errors
  • 1 V operation at 2Rx8 rank matches server memory-controller expectations
  • 288-pin RDIMM form factor verified for Supermicro H14DSH motherboard

384GB DDR5 4800 RDIMM kit

This 384GB kit contains twelve 32GB DDR5 4800 registered ECC RDIMMs built for the Supermicro H14DSH motherboard. Each module runs at 1.1V with CL40 latency and a 2Rx8 organization that matches the board's memory controller expectations. The 288-pin form factor is the exact type the platform requires for full population.

Upgrade from smaller or mixed-capacity kits

Adding this kit replaces partial fills or mismatched modules that limit total capacity or force the controller to run at reduced speeds. The jump is worth it when the workload needs the full 384GB address space and the stability of registered ECC across every slot. Systems that cannot accept twelve RDIMMs or that require a different voltage or rank layout will not benefit.

DDR5 4800 registered ECC limits

The DDR5 4800 standard sets the baseline data rate and timing the modules operate at when fully populated. Registered buffering and ECC add latency overhead compared to unbuffered non-ECC memory but are mandatory for the platform's error-correction and signal-integrity requirements. Boards that do not support registered DDR5 RDIMMs or that cap maximum capacity below 384GB cannot use this kit.

Přednosti

  • 384 GB total capacity across 12 modules of 32 GB each
  • DDR5 4800 speed with CL40 latency runs at rated frequency
  • Registered ECC design offloads controller and corrects single-bit errors
  • 1 V operation at 2Rx8 rank matches server memory-controller expectations
  • 288-pin RDIMM form factor verified for Supermicro H14DSH motherboard

Specifikace

BrandNEMIX RAM
SeriesNEMIX RAM Original Series Server Memory
ModelDDR5 ECC RDIMM Registered Server Memory
Part NumberMR38400-328K12
Capacity384GB (12 x 32GB)
Type288-Pin DDR5 RDIMM
SpeedDDR5 4800 (PC5 38400)
CAS LatencyCL40
Voltage1.10V
ECCYes
Buffered/RegisteredRegistered
Rank2Rx8
ChipsetMajor OEM Samsung, Micron, Hynix
Heat SpreaderNo
Compatible SystemSupermicro
FeaturesDDR5 ECC RDIMM Motherboard Compatible
Package Content384GB 12X32GB DDR5 4800MHz PC5-38400 2Rx8 1.1V 288-PIN ECC RDIMM KIT

Další verze tohoto modelu

Dalších 5 v této řadě

Stejná řada, jiná paměť, chladič nebo takt — porovnejte, než se rozhodnete.

Otázky k tomuto produktu

Does this kit use the 288-pin RDIMM form factor that the Supermicro H14DSH motherboard requires?

Yes, every module in the 12 x 32 GB kit is a 288-pin DDR5 RDIMM, matching the registered DIMM slots on the H14DSH board.

What is the correct population order when installing all twelve 2Rx8 modules on the H14DSH?

Follow the motherboard manual's approved DIMM population sequence; the board's memory-controller rules dictate which slots must be filled first for full 384 GB recognition.

Will the Samsung, Micron or Hynix DRAM chips on these modules need any firmware updates or scheduled replacement?

No, the DRAM components are standard JEDEC DDR5 devices; they operate at 1.1 V with CL40 timing and have no user-serviceable firmware or replacement schedule.

Také v této kategorii

Zákazníci také porovnávali

Stejná kategorie, stejná pokladna — osm měn a kurz zamčený na 30 minut.