Přijímáme kryptoměny — takže to, co držíte, můžete utratit za skutečný hardware.Plaťte kryptem, utrácejte ho za skutečný hardware. Pojištěná doprava zdarma po celém světě nad 399 $. Neutrální přepravní krabice bez loga, odesílané z Německa.Pojištěná doprava zdarma nad 399 $. Jakmile se otevře pokladna, je váš kurz zablokovaný na 30 minut.Kurz zablokovaný na 30 minut. Každý výrobek je zapečetěný, jeho sériové číslo je zkontrolované a vztahuje se na něj 24měsíční záruka.Zapečetěno, záruka 24 měsíců.

Sledované položky Přihlásit se
Green bare circuit board DDR5 RDIMM module with black memory chips and gold edge connector

NEMIX RAM

NEMIX RAM 48GB DDR5 4800 CL40 2Rx8 1.1V ECC Registered RDIMM Supermicro H13SSH memory upgrade

SKU CH-CFM4-3ZKF6

48GB DDR5-4800 Registered ECC RDIMM built to the exact rank, voltage and timing the Supermicro H13SSH expects

  • Capacity48GB
  • Type288-Pin DDR5 RDIMM
  • SpeedDDR5 4800 (PC5 38400)
  • CAS LatencyCL40
  • Voltage1.10V
  • ECCYes

Size 48GB

Zobrazit dalších 30 konfigurací
  • Exact-match 48 GB DDR5-4800 CL40 2Rx8 RDIMM for full-speed recognition
  • Verified fit for Supermicro H13SSH motherboard with 288-pin registered form factor
  • Registered ECC design offloads controller and corrects single-bit errors automatically
  • Lifetime replacement warranty with free US-based technical support included
  • Check system manual for supported capacities and DIMM population rules before install

48GB DDR5 ECC RDIMM for Supermicro H13SSH

This 48GB DDR5 4800 Registered ECC module is built for the Supermicro H13SSH motherboard. It uses the 288-pin RDIMM form factor and 2Rx8 organisation that the board's memory controller expects. The exact voltage, rank structure and timing let the system recognise full capacity at rated speed without manual tuning. It is not for platforms that require unbuffered UDIMMs or SODIMM modules.

Thermals and power draw

Operating at 1.10V standard DDR5 voltage, the module draws minimal power per slot and runs without a heat spreader. Registered buffering reduces electrical load on the memory controller, helping stability when every slot is populated. No active cooling is required under normal server airflow. Fan noise and thermal output remain dictated by the chassis design, not the memory itself.

Registered ECC with 2Rx8 organisation

The single specification that decides fitment is the Registered ECC 2Rx8 architecture at CL40. This combination matches the H13SSH memory population rules so the board can run fully populated at 4800 MT/s. Boards that only accept unbuffered non-ECC UDIMMs or different rank configurations will not support this module. Verify your manual for approved DIMM order and maximum capacity per slot before purchase.

Přednosti

  • Exact-match 48 GB DDR5-4800 CL40 2Rx8 RDIMM for full-speed recognition
  • Verified fit for Supermicro H13SSH motherboard with 288-pin registered form factor
  • Registered ECC design offloads controller and corrects single-bit errors automatically
  • Lifetime replacement warranty with free US-based technical support included
  • Check system manual for supported capacities and DIMM population rules before install

Specifikace

BrandNEMIX RAM
SeriesNEMIX RAM Original Series Server Memory
ModelDDR5 ECC RDIMM Registered Server Memory
Part NumberMR38400-4828K1
Capacity48GB
Type288-Pin DDR5 RDIMM
SpeedDDR5 4800 (PC5 38400)
CAS LatencyCL40
Voltage1.10V
ECCYes
Buffered/RegisteredRegistered
Rank2Rx8
ChipsetMajor OEM Samsung, Micron, Hynix
Heat SpreaderNo
Compatible SystemSupermicro
FeaturesDDR5 ECC RDIMM Motherboard Compatible
Package Content48GB DDR5 4800MHz PC5-38400 2Rx8 1.1V 288-PIN ECC RDIMM KIT

Další verze tohoto modelu

Dalších 5 v této řadě

Stejná řada, jiná paměť, chladič nebo takt — porovnejte, než se rozhodnete.

Otázky k tomuto produktu

How do I install the 288-pin RDIMM in the Supermicro H13SSH, and what step is often missed?

Power down and unplug the server, open the chassis, locate the DDR5 slots, and align the module's key notch with the slot before pressing firmly until both retention clips click; the step often missed is checking the motherboard manual for the exact DIMM population order required for 2Rx8 registered modules.

What maintenance or replacement will this 48GB DDR5-4800 ECC RDIMM need over time?

No routine maintenance is required for the module itself; keep the server's air filters clean and fans functional so the 1.10V DRAM stays within thermal limits, and replace the unit only if ECC logs report uncorrectable errors or the system fails to train at 4800 MT/s.

What limit appears first when this 2Rx8 CL40 registered memory runs sustained workloads?

The registered buffer and ECC logic add latency, so the CL40 timing at 4800 MT/s becomes the bottleneck before bandwidth saturates, especially with all channels fully populated on the H13SSH.

Také v této kategorii

Zákazníci také porovnávali

Stejná kategorie, stejná pokladna — osm měn a kurz zamčený na 30 minut.