Přijímáme kryptoměny — takže to, co držíte, můžete utratit za skutečný hardware.Plaťte kryptem, utrácejte ho za skutečný hardware. Pojištěná doprava zdarma po celém světě nad 399 $. Neutrální přepravní krabice bez loga, odesílané z Německa.Pojištěná doprava zdarma nad 399 $. Jakmile se otevře pokladna, je váš kurz zablokovaný na 30 minut.Kurz zablokovaný na 30 minut. Každý výrobek je zapečetěný, jeho sériové číslo je zkontrolované a vztahuje se na něj 24měsíční záruka.Zapečetěno, záruka 24 měsíců.

Sledované položky Přihlásit se

NEMIX RAM

NEMIX RAM 64GB (4x16GB) DDR5 5600 CL46 1.1V ECC Registered RDIMM for Supermicro H13DSG-OM

SKU CH-HP0X-FKRS3

A 64GB kit of four 16GB DDR5-5600 CL46 ECC registered RDIMMs at 1.1V, validated for the Supermicro H13DSG-OM motherboard

  • Capacity64GB (4 x 16GB)
  • Type288-Pin DDR5 RDIMM
  • SpeedDDR5 5600 (PC5 44800)
  • CAS LatencyCL46
  • Voltage1.10V
  • ECCYes
  • 64 GB total capacity with four 16 GB modules for full population
  • DDR5 5600 speed (PC5-44800) matches the motherboard rated frequency
  • CL46 CAS latency at 1.1 V delivers rated performance without overclocking
  • Registered ECC architecture corrects single-bit errors and stabilises every slot
  • 288-pin RDIMM form factor is the exact type the H13DSG-OM requires

Supermicro H13DSG-OM DDR5 Upgrade

This 64GB kit contains four 16GB DDR5 Registered ECC RDIMMs built to the exact specifications the Supermicro H13DSG-OM motherboard expects. The modules arrive new and ready to install in the board's 288-pin slots without configuration guesswork.

64GB Registered ECC Headroom

Running at DDR5-5600 with CL46 latency and 1.10V, the kit delivers 64GB of error-correcting capacity across four fully populated channels. Registered buffering keeps the memory controller stable when every slot is filled, while ECC corrects single-bit errors before they affect workloads.

Replaces Mismatched or Smaller Kits

The jump is worth it when a server currently runs on mixed-capacity modules, non-ECC memory, or a partial population that leaves channels empty. Builders who need unbuffered UDIMMs, SODIMMs, or speeds other than DDR5-5600 should look elsewhere.

Přednosti

  • 64 GB total capacity with four 16 GB modules for full population
  • DDR5 5600 speed (PC5-44800) matches the motherboard rated frequency
  • CL46 CAS latency at 1.1 V delivers rated performance without overclocking
  • Registered ECC architecture corrects single-bit errors and stabilises every slot
  • 288-pin RDIMM form factor is the exact type the H13DSG-OM requires

Specifikace

BrandNEMIX RAM
SeriesNEMIX RAM Original Series Server Memory
ModelDDR5 ECC RDIMM Registered Server Memory
Part NumberMR44800-618K4
Capacity64GB (4 x 16GB)
Type288-Pin DDR5 RDIMM
SpeedDDR5 5600 (PC5 44800)
CAS LatencyCL46
Voltage1.10V
ECCYes
Buffered/RegisteredRegistered
Rank1Rx8
ChipsetMajor OEM Samsung, Micron, Hynix
Heat SpreaderNo
Compatible SystemSupermicro
FeaturesDDR5 ECC RDIMM Motherboard Compatible
Package Content64GB 4X16GB DDR5 5600MHz PC5-44800 1Rx8 1.1V 288-PIN ECC RDIMM KIT

Další verze tohoto modelu

Dalších 5 v této řadě

Stejná řada, jiná paměť, chladič nebo takt — porovnejte, než se rozhodnete.

Otázky k tomuto produktu

Will the 288-pin DDR5 RDIMM kit run alongside existing 1Rx8 modules in the Supermicro H13DSG-OM?

The kit uses 1Rx8 registered ECC DDR5 at 1.1 V and CL46; populate remaining slots following the board's population rules and the memory controller will recognise the full 64 GB at 5600 MT/s.

How can I verify the 64 GB kit is detected at 5600 speed and ECC is active after installation?

Enter BIOS and confirm the total capacity shows 64 GB, the frequency reads 5600 MT/s (PC5-44800), and ECC status reports enabled for each DIMM.

Does the package include anything besides the four 16 GB RDIMMs?

The box contains only the 4×16 GB DDR5 5600 CL46 1.1 V ECC registered RDIMM modules; no heat spreaders, cables or additional accessories are supplied.

Také v této kategorii

Zákazníci také porovnávali

Stejná kategorie, stejná pokladna — osm měn a kurz zamčený na 30 minut.