Přijímáme kryptoměny — takže to, co držíte, můžete utratit za skutečný hardware.Plaťte kryptem, utrácejte ho za skutečný hardware. Pojištěná doprava zdarma po celém světě nad 399 $. Neutrální přepravní krabice bez loga, odesílané z Německa.Pojištěná doprava zdarma nad 399 $. Jakmile se otevře pokladna, je váš kurz zablokovaný na 30 minut.Kurz zablokovaný na 30 minut. Každý výrobek je zapečetěný, jeho sériové číslo je zkontrolované a vztahuje se na něj 24měsíční záruka.Zapečetěno, záruka 24 měsíců.

Sledované položky Přihlásit se
Two green DDR5 RDIMM modules without heat spreaders

NEMIX RAM

NEMIX RAM 96GB 2x48GB DDR5 4800 ECC RDIMM CL40 2Rx8 1.1V 288-pin Supermicro H13DSG-O-CPU-D memory upgrade

SKU CH-XHXN-BY9Y9

96 GB DDR5-4800 ECC registered server kit in two 48 GB 2Rx8 modules at 1.1 V CL40 for Supermicro H13DSG-O-CPU-D

  • Capacity96GB (2 x 48GB)
  • Type288-Pin DDR5 RDIMM
  • SpeedDDR5 4800 (PC5 38400)
  • CAS LatencyCL40
  • Voltage1.10V
  • ECCYes

Size 96GB 2X48GB

Zobrazit dalších 30 konfigurací
  • 96 GB total capacity from two 48 GB modules for high-density server workloads
  • DDR5 4800 speed with CL40 latency delivers rated bandwidth for Supermicro H13DSG-O-CPU-D
  • Registered ECC architecture corrects single-bit errors and buffers signals for full-slot stability
  • 1 V operating voltage matches platform spec for efficient power draw
  • 288-pin RDIMM form factor ensures exact mechanical and electrical fit in the target motherboard

Exact DDR5-4800 upgrade for Supermicro

This 96GB kit delivers two 48GB DDR5-4800 Registered ECC RDIMMs built to the board's required 288-pin form factor. The CL40 1.1V 2Rx8 specification matches the memory controller so the system recognises full capacity at rated speed. It is intended for administrators who need a validated, single-SKU memory expansion for this specific Supermicro server platform.

Registered ECC stability under sustained load

Registered buffering offloads the memory controller so every slot runs fully populated without signal degradation during continuous operation. On-die ECC detects and corrects single-bit errors in real time, preventing silent data corruption and unplanned reboots that would interrupt production workloads. The 1.1V operating voltage maintains consistent power draw across extended duty cycles.

Guided installation with population rules

The 288-pin RDIMMs seat in the motherboard's DDR5 DIMM slots, but the Supermicro H13DSG-O-CPU-D enforces a strict population order that must be followed from the system manual. Installing modules in the wrong sequence or mixing ranks will cause the board to halt at POST or report reduced capacity. Verify the approved slot layout and maximum supported density per channel before fitting the kit.

Přednosti

  • 96 GB total capacity from two 48 GB modules for high-density server workloads
  • DDR5 4800 speed with CL40 latency delivers rated bandwidth for Supermicro H13DSG-O-CPU-D
  • Registered ECC architecture corrects single-bit errors and buffers signals for full-slot stability
  • 1 V operating voltage matches platform spec for efficient power draw
  • 288-pin RDIMM form factor ensures exact mechanical and electrical fit in the target motherboard

Specifikace

BrandNEMIX RAM
SeriesNEMIX RAM Original Series Server Memory
ModelDDR5 ECC RDIMM Registered Server Memory
Part NumberMR38400-4828K2
Capacity96GB (2 x 48GB)
Type288-Pin DDR5 RDIMM
SpeedDDR5 4800 (PC5 38400)
CAS LatencyCL40
Voltage1.10V
ECCYes
Buffered/RegisteredRegistered
Rank2Rx8
ChipsetMajor OEM Samsung, Micron, Hynix
Heat SpreaderNo
Compatible SystemSupermicro
FeaturesDDR5 ECC RDIMM Motherboard Compatible
Package Content96GB 2X48GB DDR5 4800MHz PC5-38400 2Rx8 1.1V 288-PIN ECC RDIMM KIT

Další verze tohoto modelu

Dalších 5 v této řadě

Stejná řada, jiná paměť, chladič nebo takt — porovnejte, než se rozhodnete.

Otázky k tomuto produktu

Does the 1.1 V DDR5-4800 kit generate noticeably more heat when the server runs at full load all day?

The modules operate at the standard DDR5 voltage of 1.1 V and have no heat spreader, so thermal output matches typical registered DDR5 DIMMs; ensure your chassis airflow follows Supermicro's population guidelines.

What must the Supermicro H13DSG-O-CPU-D motherboard already provide for this 2Rx8 RDIMM kit to function?

The board needs DDR5 RDIMM slots that support registered ECC memory at 4800 MT/s, 1.1 V operation, and the correct population sequence for 2Rx8 modules as detailed in the motherboard manual.

Will the CL40 DDR5-4800 modules run at rated speed alongside other DDR5 RDIMMs I keep in the remaining slots?

All installed DDR5 RDIMMs must share the same voltage, registered ECC design, and supported speed; the motherboard will train every slot to the lowest common timing, so matching CL40 4800 MT/s modules is recommended.

Také v této kategorii

Zákazníci také porovnávali

Stejná kategorie, stejná pokladna — osm měn a kurz zamčený na 30 minut.