Systor SYSUSB30100-23 USB 3.0/3.1 Duplicator 1 to 23
- USB Flash Drive Dup…
- 1 to 23
Vi tager imod kryptovaluta — så den krypto, du ejer, kan købe rigtig hardware.Betal med krypto, brug det på rigtig hardware. Gratis, forsikret levering til hele verden ved køb over 399 $. Neutrale, umærkede papkasser, sendt fra Tyskland.Gratis, forsikret levering over 399 $. Din kurs låses i 30 minutter, så snart kassen åbner.Kurs låst i 30 minutter. Hver vare er forseglet, har kontrolleret serienummer og er dækket af 24 måneders garanti.Forseglet, 24 måneders garanti.
Systor
Standalone USB flash duplicator copies up to 63 drives at 33 MB/s with synchronous or asynchronous modes and DoD-compliant erase
Target Size 1 to 63
De overstregede versioner findes, men er ikke på lager her.
DATA TRANSFER RATE USB 2.0/2.1 - 2GB/min [33MB/sec]
This Systor duplicator copies up to 63 USB flash drives simultaneously without a computer. It supports USB 1.1, 2.0, and 3.0 devices at speeds up to 33 MB/s. The unit features a 256 MB buffer, an LCD screen, and four-key controls for standalone operation. Synchronous and asynchronous copy modes are both available.
It suits organisations that need to duplicate or securely erase large batches of USB media on a regular basis. The 600 W dual power supply and SATA connector support continuous, unattended runs. Buyers who only need occasional single-drive copies or require fewer than 16 target ports should consider a smaller model. The standalone design removes the need for host software or a connected PC.
The single specification that determines suitability is the 1-to-63 target range. If your workflow demands more than 63 concurrent copies, this unit cannot meet that volume. If you need 63 or fewer targets, the asynchronous mode and 33 MB/s transfer rate handle the load. No other figure in the data changes this core capacity limit.
| Type | USB Flash Drive Duplicator |
|---|---|
| Target | 1 to 63 |
| Buffer Memory | 256 MB |
| Supported Media | USB 1.1, USB 2.0, & USB 3.0 |
| Data Transfer Rate | 33MB/s |
| Language Support | English, Japanese, Spanish, Portuguese |
| Display | LCD Screen |
| Operating Type | Standalone |
| Connector | SATA |
| Panel Color | Black |
| Load Type | Slot |
| Key Features | Synchronous or Asynchronous mode |
| Features | Quick Copy: FAT16/32, NTFS, Linux(EXT2/EXT3/EXT4) Whole Media Copy: All Formats |
| Power Supply | 115/230 V, 50/60 Hz, 600 W (300w x2) |
Andre versioner af denne model
Samme familie, men med anden hukommelse, køler eller clockfrekvens — sammenlign, før du bestemmer dig.
The duplicator supports USB 3.0, so drives that operate at USB 3.0 speeds are needed to achieve the 33 MB/s rate.
Yes, the unit lists USB 1.1, USB 2.0 and USB 3.0 as supported media, so legacy USB 1.1 drives can be used as targets.
The duplicator performs a bit-for-bit hardware comparison after each job and shows the verification result on the LCD display.
Også på denne hylde
Samme hylde, samme kasse — otte mønter og 30 minutters kurslås.
Det du betaler med, og det du ser priserne i.
Sendes fra din tegnebog i kassen
Kun til visning — kataloget er prissat i USD
Ingen valuta matcher det.
Vælg det sprog, siden taler til dig på.
Ingen sprog matcher.
Ny her?
Har du allerede en?
Der findes ingen automatisk nulstilling: denne butik sender ingen e-mails, så der er intet engangslink at bede om. Efterlad adressen på kontoen, så bliver den behandlet manuelt.
Anmodning registreret
Der er intet på vej til din indbakke — denne butik sender slet ingen e-mails. Nogen behandler dem manuelt.
Kom du i tanke om den?