Systor SYSUSB30100-23 USB 3.0/3.1 Duplicator 1 to 23
- USB Flash Drive Dup…
- 1 to 23
Prijímame kryptomeny — takže mince, ktoré držíte, môžete zameniť za skutočný hardvér.Plaťte v krypte, miňte ho na skutočný hardvér. Poistená doprava zadarmo po celom svete nad 399 $. Neutrálne kartóny bez potlače, odosielané z Nemecka.Poistená doprava zadarmo nad 399 $. Váš kurz je zablokovaný na 30 minút hneď po otvorení pokladne.Kurz zablokovaný na 30 minút. Každý produkt je zapečatený, jeho sériové číslo je overené a vzťahuje sa naň 24-mesačná záruka.Zapečatené, 24-mesačná záruka.
Systor
Standalone USB flash duplicator copies up to 63 drives at 33 MB/s with synchronous or asynchronous modes and DoD-compliant erase
Target Size 1 to 63
Preškrtnuté verzie existujú, ale nie sú tu skladom.
DATA TRANSFER RATE USB 2.0/2.1 - 2GB/min [33MB/sec]
This Systor duplicator copies up to 63 USB flash drives simultaneously without a computer. It supports USB 1.1, 2.0, and 3.0 devices at speeds up to 33 MB/s. The unit features a 256 MB buffer, an LCD screen, and four-key controls for standalone operation. Synchronous and asynchronous copy modes are both available.
It suits organisations that need to duplicate or securely erase large batches of USB media on a regular basis. The 600 W dual power supply and SATA connector support continuous, unattended runs. Buyers who only need occasional single-drive copies or require fewer than 16 target ports should consider a smaller model. The standalone design removes the need for host software or a connected PC.
The single specification that determines suitability is the 1-to-63 target range. If your workflow demands more than 63 concurrent copies, this unit cannot meet that volume. If you need 63 or fewer targets, the asynchronous mode and 33 MB/s transfer rate handle the load. No other figure in the data changes this core capacity limit.
| Type | USB Flash Drive Duplicator |
|---|---|
| Target | 1 to 63 |
| Buffer Memory | 256 MB |
| Supported Media | USB 1.1, USB 2.0, & USB 3.0 |
| Data Transfer Rate | 33MB/s |
| Language Support | English, Japanese, Spanish, Portuguese |
| Display | LCD Screen |
| Operating Type | Standalone |
| Connector | SATA |
| Panel Color | Black |
| Load Type | Slot |
| Key Features | Synchronous or Asynchronous mode |
| Features | Quick Copy: FAT16/32, NTFS, Linux(EXT2/EXT3/EXT4) Whole Media Copy: All Formats |
| Power Supply | 115/230 V, 50/60 Hz, 600 W (300w x2) |
Ďalšie verzie tohto modelu
Rovnaký rad, iná pamäť, chladič alebo frekvencia — porovnajte pred rozhodnutím.
The duplicator supports USB 3.0, so drives that operate at USB 3.0 speeds are needed to achieve the 33 MB/s rate.
Yes, the unit lists USB 1.1, USB 2.0 and USB 3.0 as supported media, so legacy USB 1.1 drives can be used as targets.
The duplicator performs a bit-for-bit hardware comparison after each job and shows the verification result on the LCD display.
Aj v tomto oddelení
Rovnaké oddelenie, rovnaká pokladňa — osem mien a kurz zablokovaný na 30 minút.
Mena, v ktorej platíte, a mena, v ktorej sa zobrazujú ceny.
Odoslané z vašej peňaženky na pokladni
Len na zobrazenie — katalóg je uvedený v dolároch
Žiadna mena nezodpovedá.
Vyberte jazyk, v ktorom s vami bude web komunikovať.
Žiadny jazyk nezodpovedá.
Ste tu prvýkrát?
Účet už máte?
Automatický reset hesla neexistuje: tento obchod neposiela žiadne e-maily, takže neexistuje jednorazový odkaz, o ktorý by ste mohli požiadať. Nechajte adresu na účte — niekto sa jej ujme ručne.
Žiadosť zaznamenaná
Do vašej schránky nič nepríde — tento obchod neposiela vôbec žiadne e-maily. Niekto sa o to postará ručne.
Spomenuli ste si?