E3D Online spoolWorks EDGE Filament 2.85mm 750g Light Grey06 3d printers accessory

Filament for 3D printing

E3D Online spoolWorks EDGE is a PETG-based filament supplied on a 750 g spool with a 2.85 mm diameter. It is formulated for makers who want the toughness of ABS together with the easy handling of PLA. The material prints with no unpleasant fumes or odours and produces a naturally glossy finish. It suits functional parts, prototypes and everyday models that need strength and reliable layer adhesion.

Check printer compatibility first

Verify that your 3D printer accepts 2.85 mm filament before ordering. The spool weighs 750 g, so confirm that your spool holder can accommodate that mass and width. A heated bed is recommended and a light coating of gluestick helps the first layer stick reliably. The filament pairs with E3D Scaffold support material if you need clean breakaway supports for complex geometries.

Low warp and stable extrusion

Edge is engineered for super-low contraction, which greatly reduces warping during printing. Managed viscosity and melt strength allow accurate overhangs and tight bridges without excessive cooling. The material maintains consistent flow at standard PETG temperatures, so fan noise and power draw stay typical for your printer. Parts come out strong and stiff with almost isotropic layer bonding.