EZ Dupe, Inc. HD Leopardo H09PROHEB 1-to-9 SATA duplicator
- Hard Drive Duplicat…
- Black
Me võtame vastu krüptoraha — nii saab teie hoitav krüptoraha osta päris riistvara.Makske krüptorahaga, kulutage seda päris riistvarale. Tasuta kindlustatud tarne kogu maailmas, üle 399 $. Lihtsad, kaubamärgita väliskarbid, saadetud Saksamaalt.Tasuta kindlustatud tarne üle 399 $. Teie kurss lukustatakse 30 minutiks kohe, kui kassa avaneb.Kurss lukustatud 30 minutiks. Iga toode on pitseeritud, selle seerianumber on kontrollitud ja sellel kehtib 24-kuuline garantii.Pitseeritud, 24-kuulise garantiiga.
EZ Dupe, Inc.
Standalone duplicator copies up to 23 SATA drives at 300MB/s with four copy and seven erase modes
Data Transfer Rate 300MB/s
Läbikriipsutatud versioonid on olemas, kuid neid pole siin saadaval.
The EZ Dupe HD Leopardo H23PROHEB copies one SATA source to 23 targets at up to 300 MB/s. It handles both 3.5 and 2.5 inch drives without adapters and runs standalone with a 20 x 2 LCD and Athena controller. The 128 MB buffer keeps throughput steady across all slots. Operates on 115 to 230 V AC at 50 or 60 Hz.
Moving up from a one-to-one copier or a unit limited to lower transfer rates adds 23 simultaneous targets and 18 GB/min per slot. The jump is worth it when you must image dozens of drives daily or need four copy modes and seven erase modes including DoD 5220.22-M three-pass and seven-pass. Single-drive workflows or occasional backups will not use the capacity.
Verify every target drive uses a SATA interface and fits 3.5 or 2.5 inch form factor. Confirm the rack or bench can supply 115 to 230 V AC at 50 or 60 Hz for the built-in power supply. No host computer or software is required, so ensure physical access to the front-loading slots for unattended operation.
| Brand | EZ Dupe |
|---|---|
| Type | Hard Drive Duplicator |
| Model | HD Leopardo |
| Part Number | H23PROHEB |
| Panel Color | Black |
| Operating Type | Standalone |
| Display | 20 x 2 LCD |
| Connector | SATA |
| Target | 1 to 23 |
| Buffer Memory | 128M |
| Controller | Athena Controller |
| Supported Media | SATA Hard Drive Disk / SATA Solid State Drives |
| Data Transfer Rate | 300MB/s |
| Load Type | Slot |
| Key Features | Duplication |
| Features | Indication Lights |
| Power Supply | AC: 115-230 V, 50/60 Hz |
Selle mudeli teised versioonid
Sama seeria, erinev mälumaht, jahutus või taktsagedus — võrrelge enne otsustamist.
The unit provides 23 target slots, each accepting a 3.5" or 2.5" SATA drive without an adapter.
Insert the source drive in the source slot and target drives in the target slots, power on the unit, select the desired copy mode on the 20 x 2 LCD, then press Start; the common mistake is pressing Start before confirming the mode.
The slot-load SATA connectors and the internal power distribution board are the parts most likely to wear out after repeated drive insertions.
Veel samast osakonnast
Sama osakond, sama kassa — kaheksa krüptovaluutat ja 30-minutiline kursilukk.
See, millega maksate, ja see, milles vaatate hindu.
Saadetud teie rahakotist kassas
Ainult kuvamiseks — kataloogi hinnad on dollarites
Ükski vääring ei vasta sellele.
Valige keel, milles sait teiega räägib.
Ükski keel ei vasta.
Esimest korda siin?
Teil on juba konto?
Automaatset lähtestamist ei ole: see pood ei saada ühtegi e-kirja, seega pole ka ühekordset linki, mida küsida. Jätke aadress kontole alles, seda käsitletakse käsitsi.
Päring registreeritud
Teie postkasti ei jõua midagi — see pood ei saada e-kirju üldse. Keegi tegeleb sellega käsitsi.
Tuli meelde?