EZ Dupe, Inc. HD Leopardo H09PROHEB 1-to-9 SATA duplicator
- Hard Drive Duplicat…
- Black
Sprejemamo kriptovalute — tako lahko sredstva, ki jih imate, kupijo pravo strojno opremo.Plačajte v kriptovaluti, zapravite jo za pravo strojno opremo. Brezplačna zavarovana dostava po vsem svetu nad 399 $. Nevtralni kartoni brez znamke, poslani iz Nemčije.Brezplačna zavarovana dostava nad 399 $. Vaš tečaj je zaklenjen za 30 minut, takoj ko se odpre blagajna.Tečaj zaklenjen 30 minut. Vsak izdelek je zapečaten, njegova serijska številka preverjena, in krit z 24-mesečno garancijo.Zapečateno, 24-mesečna garancija.
EZ Dupe, Inc.
Standalone duplicator copies up to 23 SATA drives at 300MB/s with four copy and seven erase modes
Data Transfer Rate 300MB/s
Prečrtane različice obstajajo, vendar tukaj niso na voljo.
The EZ Dupe HD Leopardo H23PROHEB copies one SATA source to 23 targets at up to 300 MB/s. It handles both 3.5 and 2.5 inch drives without adapters and runs standalone with a 20 x 2 LCD and Athena controller. The 128 MB buffer keeps throughput steady across all slots. Operates on 115 to 230 V AC at 50 or 60 Hz.
Moving up from a one-to-one copier or a unit limited to lower transfer rates adds 23 simultaneous targets and 18 GB/min per slot. The jump is worth it when you must image dozens of drives daily or need four copy modes and seven erase modes including DoD 5220.22-M three-pass and seven-pass. Single-drive workflows or occasional backups will not use the capacity.
Verify every target drive uses a SATA interface and fits 3.5 or 2.5 inch form factor. Confirm the rack or bench can supply 115 to 230 V AC at 50 or 60 Hz for the built-in power supply. No host computer or software is required, so ensure physical access to the front-loading slots for unattended operation.
| Brand | EZ Dupe |
|---|---|
| Type | Hard Drive Duplicator |
| Model | HD Leopardo |
| Part Number | H23PROHEB |
| Panel Color | Black |
| Operating Type | Standalone |
| Display | 20 x 2 LCD |
| Connector | SATA |
| Target | 1 to 23 |
| Buffer Memory | 128M |
| Controller | Athena Controller |
| Supported Media | SATA Hard Drive Disk / SATA Solid State Drives |
| Data Transfer Rate | 300MB/s |
| Load Type | Slot |
| Key Features | Duplication |
| Features | Indication Lights |
| Power Supply | AC: 115-230 V, 50/60 Hz |
Druge različice tega modela
Ista družina, različen pomnilnik, hladilnik ali takt — primerjajte, preden se odločite.
The unit provides 23 target slots, each accepting a 3.5" or 2.5" SATA drive without an adapter.
Insert the source drive in the source slot and target drives in the target slots, power on the unit, select the desired copy mode on the 20 x 2 LCD, then press Start; the common mistake is pressing Start before confirming the mode.
The slot-load SATA connectors and the internal power distribution board are the parts most likely to wear out after repeated drive insertions.
Tudi v tem oddelku
Ista polica, ista blagajna — osem kriptovalut in 30-minutni zaklep tečaja.
V čem plačujete in v čem berete cene.
Poslano iz Vaše denarnice ob blagajni
Samo za prikaz — katalog je cenovno izražen v dolarjih
Nobena valuta ne ustreza.
Izberite jezik, v katerem Vam govori spletna stran.
Ni ustreznega jezika.
Prvič tu?
Že imate račun?
Samodejne ponastavitve ni: ta trgovina ne pošilja e-pošte, zato ni enkratne povezave, ki bi jo lahko zahtevali. Pustite naslov na računu — nekdo ga bo obravnaval ročno.
Zahteva zabeležena
V Vašo elektronsko pošto ne prihaja nič — ta trgovina ne pošilja nobene e-pošte. Zahteve nekdo obravnava ročno.
Ste se spomnili?