暗号資産でのお支払いに対応—お手持ちのコインで、本物のハードウェアをご購入いただけます。暗号資産で支払い、本物のハードウェアに使う。 $399以上のご注文で、世界中どこでも送料無料（保険付き）。無地・ノーブランドの外箱で、ドイツから発送いたします。$399以上で送料無料（保険付き）。 注文手続きを開始すると、レートは30分間ロックされます。レートは30分間ロック。 すべての商品は未開封で、シリアル番号を確認した上で、24か月保証が付いています。未開封、24か月保証。

ウォッチリスト ログイン
Black standalone duplicator with 23 drive slots and LCD display

EZ Dupe, Inc.

EZ Dupe, Inc. HD Leopardo H23PROHEB 1-to-23 SATA Duplicator 300MB/s 128M

SKU CH-PAXD-3XMQT

Standalone duplicator copies up to 23 SATA drives at 300MB/s with four copy and seven erase modes

  • TypeHard Drive Duplicator
  • Panel ColorBlack
  • Operating TypeStandalone
  • Display20 x 2 LCD
  • ConnectorSATA
  • Target1 to 23

Target 1 to 23

Data Transfer Rate 300MB/s

取り消し線の付いたバージョンは存在しますが、こちらでは取り扱っていません。

  • Copy 23 SATA drives simultaneously at 300MB/s per slot
  • Four copy modes including quick and full duplication options
  • Seven erase modes meeting DoD 5220.22-M security standards
  • Standalone operation requires no host computer or software
  • Supports both 2.5" and 3.5" SATA drives without adapters

23-target SATA duplicator

The EZ Dupe HD Leopardo H23PROHEB copies one SATA source to 23 targets at up to 300 MB/s. It handles both 3.5 and 2.5 inch drives without adapters and runs standalone with a 20 x 2 LCD and Athena controller. The 128 MB buffer keeps throughput steady across all slots. Operates on 115 to 230 V AC at 50 or 60 Hz.

Upgrade from single-bay or slower duplicators

Moving up from a one-to-one copier or a unit limited to lower transfer rates adds 23 simultaneous targets and 18 GB/min per slot. The jump is worth it when you must image dozens of drives daily or need four copy modes and seven erase modes including DoD 5220.22-M three-pass and seven-pass. Single-drive workflows or occasional backups will not use the capacity.

Check drive fit and power

Verify every target drive uses a SATA interface and fits 3.5 or 2.5 inch form factor. Confirm the rack or bench can supply 115 to 230 V AC at 50 or 60 Hz for the built-in power supply. No host computer or software is required, so ensure physical access to the front-loading slots for unattended operation.

特長

  • Copy 23 SATA drives simultaneously at 300MB/s per slot
  • Four copy modes including quick and full duplication options
  • Seven erase modes meeting DoD 5220.22-M security standards
  • Standalone operation requires no host computer or software
  • Supports both 2.5" and 3.5" SATA drives without adapters

仕様

BrandEZ Dupe
TypeHard Drive Duplicator
ModelHD Leopardo
Part NumberH23PROHEB
Panel ColorBlack
Operating TypeStandalone
Display20 x 2 LCD
ConnectorSATA
Target1 to 23
Buffer Memory128M
ControllerAthena Controller
Supported MediaSATA Hard Drive Disk / SATA Solid State Drives
Data Transfer Rate300MB/s
Load TypeSlot
Key FeaturesDuplication
FeaturesIndication Lights
Power SupplyAC: 115-230 V, 50/60 Hz

このモデルの他のバージョン

同シリーズにさらに 5点

同じファミリーで、メモリ・クーラー・クロックが異なります — 購入前に比較してください。

この商品に関する質問

How many SATA drives can the HD Leopardo H23PROHEB hold at once?

The unit provides 23 target slots, each accepting a 3.5" or 2.5" SATA drive without an adapter.

What is the correct sequence for starting a duplication job on this standalone duplicator?

Insert the source drive in the source slot and target drives in the target slots, power on the unit, select the desired copy mode on the 20 x 2 LCD, then press Start; the common mistake is pressing Start before confirming the mode.

Which components may need replacement after heavy use of the 23 drive slots?

The slot-load SATA connectors and the internal power distribution board are the parts most likely to wear out after repeated drive insertions.

同じ売り場の商品

よく比較されている商品

同じ売り場、同じレジ — 8種類のコインと30分間のレートロック。