نقبل الدفع بالعملة المشفرة — لذلك يمكن للعملات الرقمية التي تملكها أن تشتري أجهزة حقيقية.ادفع بالعملة المشفرة، وأنفقها على أجهزة حقيقية. شحن مؤمن مجانا إلى كل أنحاء العالم لما يتجاوز 399 US$. صناديق شحن بسيطة بلا علامة تجارية، ترسل من ألمانيا.شحن مؤمن مجانا لما يتجاوز 399 US$. يُقفل سعرك لمدة 30 دقيقة بمجرد فتح صفحة الدفع.السعر مقفل لمدة 30 دقيقة. كل قطعة مختومة، ورقمها التسلسلي متحقق منه، ومشمولة بضمان 24 شهرا.مختوم، وبضمان 24 شهرا.

قائمة الرصد تسجيل الدخول
Black standalone duplicator with 23 drive slots and LCD display

EZ Dupe, Inc.

EZ Dupe, Inc. HD Leopardo H23PROHEB 1-to-23 SATA Duplicator 300MB/s 128M

SKU CH-PAXD-3XMQT

Standalone duplicator copies up to 23 SATA drives at 300MB/s with four copy and seven erase modes

  • TypeHard Drive Duplicator
  • Panel ColorBlack
  • Operating TypeStandalone
  • Display20 x 2 LCD
  • ConnectorSATA
  • Target1 to 23

Target 1 to 23

Data Transfer Rate 300MB/s

الإصدارات المشطوبة موجودة، لكنها غير متوفرة هنا.

  • Copy 23 SATA drives simultaneously at 300MB/s per slot
  • Four copy modes including quick and full duplication options
  • Seven erase modes meeting DoD 5220.22-M security standards
  • Standalone operation requires no host computer or software
  • Supports both 2.5" and 3.5" SATA drives without adapters

23-target SATA duplicator

The EZ Dupe HD Leopardo H23PROHEB copies one SATA source to 23 targets at up to 300 MB/s. It handles both 3.5 and 2.5 inch drives without adapters and runs standalone with a 20 x 2 LCD and Athena controller. The 128 MB buffer keeps throughput steady across all slots. Operates on 115 to 230 V AC at 50 or 60 Hz.

Upgrade from single-bay or slower duplicators

Moving up from a one-to-one copier or a unit limited to lower transfer rates adds 23 simultaneous targets and 18 GB/min per slot. The jump is worth it when you must image dozens of drives daily or need four copy modes and seven erase modes including DoD 5220.22-M three-pass and seven-pass. Single-drive workflows or occasional backups will not use the capacity.

Check drive fit and power

Verify every target drive uses a SATA interface and fits 3.5 or 2.5 inch form factor. Confirm the rack or bench can supply 115 to 230 V AC at 50 or 60 Hz for the built-in power supply. No host computer or software is required, so ensure physical access to the front-loading slots for unattended operation.

أبرز المميزات

  • Copy 23 SATA drives simultaneously at 300MB/s per slot
  • Four copy modes including quick and full duplication options
  • Seven erase modes meeting DoD 5220.22-M security standards
  • Standalone operation requires no host computer or software
  • Supports both 2.5" and 3.5" SATA drives without adapters

المواصفات

BrandEZ Dupe
TypeHard Drive Duplicator
ModelHD Leopardo
Part NumberH23PROHEB
Panel ColorBlack
Operating TypeStandalone
Display20 x 2 LCD
ConnectorSATA
Target1 to 23
Buffer Memory128M
ControllerAthena Controller
Supported MediaSATA Hard Drive Disk / SATA Solid State Drives
Data Transfer Rate300MB/s
Load TypeSlot
Key FeaturesDuplication
FeaturesIndication Lights
Power SupplyAC: 115-230 V, 50/60 Hz

إصدارات أخرى من هذا الطراز

5 أخرى من الفئة نفسها

نفس الفئة، بذاكرة أو مبرّد أو تردد مختلف — قارن قبل أن تقرر.

أسئلة حول هذا المنتج

How many SATA drives can the HD Leopardo H23PROHEB hold at once?

The unit provides 23 target slots, each accepting a 3.5" or 2.5" SATA drive without an adapter.

What is the correct sequence for starting a duplication job on this standalone duplicator?

Insert the source drive in the source slot and target drives in the target slots, power on the unit, select the desired copy mode on the 20 x 2 LCD, then press Start; the common mistake is pressing Start before confirming the mode.

Which components may need replacement after heavy use of the 23 drive slots?

The slot-load SATA connectors and the internal power distribution board are the parts most likely to wear out after repeated drive insertions.

أيضًا في هذا القسم

عملاء قارنوا هذه المنتجات

نفس القسم، ونفس صفحة الدفع — ثماني عملات رقمية وقفل سعر لمدة 30 دقيقة.