EZ Dupe, Inc. HD Leopardo H09PROHEB 1-to-9 SATA duplicator
- Hard Drive Duplicat…
- Black
Prijímame kryptomeny — takže mince, ktoré držíte, môžete zameniť za skutočný hardvér.Plaťte v krypte, miňte ho na skutočný hardvér. Poistená doprava zadarmo po celom svete nad 399 $. Neutrálne kartóny bez potlače, odosielané z Nemecka.Poistená doprava zadarmo nad 399 $. Váš kurz je zablokovaný na 30 minút hneď po otvorení pokladne.Kurz zablokovaný na 30 minút. Každý produkt je zapečatený, jeho sériové číslo je overené a vzťahuje sa naň 24-mesačná záruka.Zapečatené, 24-mesačná záruka.
EZ Dupe, Inc.
Standalone duplicator copies up to 23 SATA drives at 300MB/s with four copy and seven erase modes
Data Transfer Rate 300MB/s
Preškrtnuté verzie existujú, ale nie sú tu skladom.
The EZ Dupe HD Leopardo H23PROHEB copies one SATA source to 23 targets at up to 300 MB/s. It handles both 3.5 and 2.5 inch drives without adapters and runs standalone with a 20 x 2 LCD and Athena controller. The 128 MB buffer keeps throughput steady across all slots. Operates on 115 to 230 V AC at 50 or 60 Hz.
Moving up from a one-to-one copier or a unit limited to lower transfer rates adds 23 simultaneous targets and 18 GB/min per slot. The jump is worth it when you must image dozens of drives daily or need four copy modes and seven erase modes including DoD 5220.22-M three-pass and seven-pass. Single-drive workflows or occasional backups will not use the capacity.
Verify every target drive uses a SATA interface and fits 3.5 or 2.5 inch form factor. Confirm the rack or bench can supply 115 to 230 V AC at 50 or 60 Hz for the built-in power supply. No host computer or software is required, so ensure physical access to the front-loading slots for unattended operation.
| Brand | EZ Dupe |
|---|---|
| Type | Hard Drive Duplicator |
| Model | HD Leopardo |
| Part Number | H23PROHEB |
| Panel Color | Black |
| Operating Type | Standalone |
| Display | 20 x 2 LCD |
| Connector | SATA |
| Target | 1 to 23 |
| Buffer Memory | 128M |
| Controller | Athena Controller |
| Supported Media | SATA Hard Drive Disk / SATA Solid State Drives |
| Data Transfer Rate | 300MB/s |
| Load Type | Slot |
| Key Features | Duplication |
| Features | Indication Lights |
| Power Supply | AC: 115-230 V, 50/60 Hz |
Ďalšie verzie tohto modelu
Rovnaký rad, iná pamäť, chladič alebo frekvencia — porovnajte pred rozhodnutím.
The unit provides 23 target slots, each accepting a 3.5" or 2.5" SATA drive without an adapter.
Insert the source drive in the source slot and target drives in the target slots, power on the unit, select the desired copy mode on the 20 x 2 LCD, then press Start; the common mistake is pressing Start before confirming the mode.
The slot-load SATA connectors and the internal power distribution board are the parts most likely to wear out after repeated drive insertions.
Aj v tomto oddelení
Rovnaké oddelenie, rovnaká pokladňa — osem mien a kurz zablokovaný na 30 minút.
Mena, v ktorej platíte, a mena, v ktorej sa zobrazujú ceny.
Odoslané z vašej peňaženky na pokladni
Len na zobrazenie — katalóg je uvedený v dolároch
Žiadna mena nezodpovedá.
Vyberte jazyk, v ktorom s vami bude web komunikovať.
Žiadny jazyk nezodpovedá.
Ste tu prvýkrát?
Účet už máte?
Automatický reset hesla neexistuje: tento obchod neposiela žiadne e-maily, takže neexistuje jednorazový odkaz, o ktorý by ste mohli požiadať. Nechajte adresu na účte — niekto sa jej ujme ručne.
Žiadosť zaznamenaná
Do vašej schránky nič nepríde — tento obchod neposiela vôbec žiadne e-maily. Niekto sa o to postará ručne.
Spomenuli ste si?