EZ Dupe, Inc. HD Leopardo H09PROHEB 1-to-9 SATA duplicator
- Hard Drive Duplicat…
- Black
Elfogadjuk a kriptovalutát — így az Ön birtokában lévő érmékből valódi hardvert vásárolhat.Fizessen kriptóval, és költse el valódi hardverre. 399 $ felett világszerte díjmentes a biztosított szállítás. Egyszerű, jelöletlen külső kartonok, Németországból küldve.399 $ felett díjmentes a biztosított szállítás. Az Ön árfolyama a pénztár megnyitásától számított 30 percre zárolva marad.Árfolyam zárolva 30 percre. Minden termék gyárilag zárt, sorozatszáma ellenőrzött, és 24 hónapos garancia fedezi.Zárt csomagolás, 24 hónap garancia.
EZ Dupe, Inc.
Standalone duplicator copies up to 23 SATA drives at 300MB/s with four copy and seven erase modes
Data Transfer Rate 300MB/s
Az áthúzott konfigurációk léteznek, de nem érhetők el itt.
The EZ Dupe HD Leopardo H23PROHEB copies one SATA source to 23 targets at up to 300 MB/s. It handles both 3.5 and 2.5 inch drives without adapters and runs standalone with a 20 x 2 LCD and Athena controller. The 128 MB buffer keeps throughput steady across all slots. Operates on 115 to 230 V AC at 50 or 60 Hz.
Moving up from a one-to-one copier or a unit limited to lower transfer rates adds 23 simultaneous targets and 18 GB/min per slot. The jump is worth it when you must image dozens of drives daily or need four copy modes and seven erase modes including DoD 5220.22-M three-pass and seven-pass. Single-drive workflows or occasional backups will not use the capacity.
Verify every target drive uses a SATA interface and fits 3.5 or 2.5 inch form factor. Confirm the rack or bench can supply 115 to 230 V AC at 50 or 60 Hz for the built-in power supply. No host computer or software is required, so ensure physical access to the front-loading slots for unattended operation.
| Brand | EZ Dupe |
|---|---|
| Type | Hard Drive Duplicator |
| Model | HD Leopardo |
| Part Number | H23PROHEB |
| Panel Color | Black |
| Operating Type | Standalone |
| Display | 20 x 2 LCD |
| Connector | SATA |
| Target | 1 to 23 |
| Buffer Memory | 128M |
| Controller | Athena Controller |
| Supported Media | SATA Hard Drive Disk / SATA Solid State Drives |
| Data Transfer Rate | 300MB/s |
| Load Type | Slot |
| Key Features | Duplication |
| Features | Indication Lights |
| Power Supply | AC: 115-230 V, 50/60 Hz |
A modell további verziói
Ugyanaz a termékcsalád, eltérő memória, hűtés vagy órajel — hasonlítsa össze, mielőtt dönt.
The unit provides 23 target slots, each accepting a 3.5" or 2.5" SATA drive without an adapter.
Insert the source drive in the source slot and target drives in the target slots, power on the unit, select the desired copy mode on the 20 x 2 LCD, then press Start; the common mistake is pressing Start before confirming the mode.
The slot-load SATA connectors and the internal power distribution board are the parts most likely to wear out after repeated drive insertions.
Szintén ezen a polcon
Ugyanaz a polc, ugyanaz a pénztár — nyolc pénznem és 30 perces árfolyamzár.
Amivel fizet, és amiben az árakat olvassa.
A pénztárnál küldi el a tárcájából
Csak tájékoztató jellegű — a katalógus dollárban van árazva
Nincs ilyen pénznem.
Válassza ki, milyen nyelven szóljon Önhöz az oldal.
Nincs egyező nyelv.
Először jár itt?
Már van fiókja?
Nincs automatikus visszaállítás: ez a bolt nem küld e-mailt, tehát nincs kérhető egyszer használatos link. Hagyja meg a fiókhoz tartozó címet, azt valaki kézzel átnézi.
Kérés rögzítve
Semmi nem érkezik a postafiókjába — ez a bolt egyáltalán nem küld e-mailt. Ezeket valaki kézzel intézi.
Eszébe jutott?