NEMIX RAM DDR5-5600 2TB (16x128GB) ECC RDIMM CL46 1.1V Supermicro H14SST-G memory upgrade
- 2TB (16 x 128GB)
- 288-Pin DDR5 RDIMM
Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.
A-Tech
An 8 GB DDR3L 1066 ECC registered DIMM with 4Rx8 organisation and 1.35 V operation
This 8 GB DDR3L 1066 ECC registered DIMM is built for server and workstation platforms that require error-correcting memory. The module runs at PC3L-8500 speed with a CAS latency of CL7 and operates at the low 1.35 V DDR3L voltage. It targets administrators upgrading or repairing compatible IBM-Lenovo systems.
The stick uses a standard 240-pin DIMM form factor and a 4Rx8 rank layout with major-brand chips. Registered buffering reduces electrical load on the memory controller, allowing larger memory populations in multi-socket boards. The pin-out matches the DDR3L keying so it only fits slots wired for 1.35 V operation.
At 1.35 V the module draws less power and generates less heat than standard 1.5 V DDR3, helping chassis airflow in dense rack enclosures. ECC circuitry adds minimal overhead while correcting single-bit errors in real time. The registered design keeps signal integrity stable under sustained workloads without increasing acoustic noise.
| Brand | A-Tech |
|---|---|
| Capacity | 8GB |
| Speed | DDR3L 1066 (PC3L 8500) |
| CAS Latency | CL7 |
| Voltage | 1.35V |
| ECC | Yes |
| Buffered/Registered | Registered |
| Rank | 4Rx8 |
| Chipset | Major Brand Chipset |
| Features | Major Brand Chips |
It runs at DDR3L 1066 (PC3L-8500) with CL7 latency and 1.35V operation.
A DDR3 DIMM slot with 240 pins; the registered design requires a server or workstation motherboard that supports RDIMMs.
Power down, open the chassis, align the notch on the 240-pin edge connector, press firmly until both clips lock, then verify in BIOS that ECC and registered modes are enabled.
Myös tällä osastolla
Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.
Valuutta, jolla maksetaan, sekä valuutta, jossa hinnat näytetään.
Lähetetään lompakostasi kassalla
Vain näyttöä varten — hinnat ovat Yhdysvaltain dollareissa
Valuuttaa ei löytynyt.
Valitse kieli, jolla sivusto puhuu sinulle.
Uusi täällä?
Onko sinulla jo tili?
Automaattista palautusta ei ole: kauppa ei lähetä sähköpostia lainkaan, joten kertakäyttöistä linkkiä ei ole mistä pyytää. Jätä osoite tilille, niin se käsitellään käsin.
Pyyntö kirjattu
Mikään ei ole tulossa sähköpostiisi — tämä kauppa ei lähetä sähköpostia lainkaan. Joku käsittelee nämä pyynnöt käsin.
Muistitko sen?