Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.

Seuratut tuotteet Kirjaudu sisään
Twelve green DDR5 RDIMM modules in a row, bare chips, no heat spreaders, 288 pins each

NEMIX RAM

NEMIX RAM 1.5TB 12x128GB DDR5 5600 ECC Registered RDIMM Supermicro H14DSG-OM

SKU CH-BRW2-BFDYP

1.5 TB DDR5 server memory kit with twelve 128 GB registered ECC modules rated at 5600 MHz, CL46, 1.1 V, validated for the Supermicro H14DSG-OM motherboard

  • Capacity1.5TB (12 x 128GB)
  • Type288-Pin DDR5 RDIMM
  • SpeedDDR5 5600 (PC5 44800)
  • CAS LatencyCL46
  • Voltage1.10V
  • ECCYes

Size 1.5TB 12X128GB

Näytä 30 muuta kokoonpanoa
  • 5 TB capacity from twelve 128 GB modules for dense server workloads
  • DDR5 5600 speed with CL46 latency for rated throughput
  • Registered ECC design corrects single-bit errors and buffers the memory controller
  • 10 V operation at 2Rx4 rank matches the motherboard specification
  • 288-pin RDIMM form factor verified for Supermicro H14DSG-OM compatibility

Capacity and fit

This is a 1.5TB DDR5 ECC Registered RDIMM kit built as twelve 128GB modules for the Supermicro H14DSG-OM motherboard. It delivers PC5-44800 speed at CL46 latency and runs at 1.1V using a 2Rx4 organisation.

Who it suits and who it does not

The kit is intended for administrators expanding a compatible Supermicro server to its full memory population with registered ECC modules. It will not work in systems that require unbuffered UDIMMs, SODIMM form factors, or non-ECC memory, and it cannot be used in platforms limited to lower capacities or different DDR generations.

Installation notes

Each module uses the standard 288-pin RDIMM connector and seats like any registered DIMM, but the board’s population rules must be followed exactly to reach full capacity and rated speed. Common issues include mixing ranks, skipping required slot order, or omitting a BIOS update that the motherboard manual specifies for 128GB DIMMs.

Kohokohdat

  • 5 TB capacity from twelve 128 GB modules for dense server workloads
  • DDR5 5600 speed with CL46 latency for rated throughput
  • Registered ECC design corrects single-bit errors and buffers the memory controller
  • 10 V operation at 2Rx4 rank matches the motherboard specification
  • 288-pin RDIMM form factor verified for Supermicro H14DSG-OM compatibility

Tekniset tiedot

BrandNEMIX RAM
SeriesNEMIX RAM Original Series Server Memory
ModelDDR5 ECC RDIMM Registered Server Memory
Part NumberMR44800-724K12
Capacity1.5TB (12 x 128GB)
Type288-Pin DDR5 RDIMM
SpeedDDR5 5600 (PC5 44800)
CAS LatencyCL46
Voltage1.10V
ECCYes
Buffered/RegisteredRegistered
Rank2Rx4
ChipsetMajor OEM Samsung, Micron, Hynix
Heat SpreaderNo
Compatible SystemSupermicro
FeaturesDDR5 ECC RDIMM Motherboard Compatible
Package Content1.5TB 12X128GB DDR5 5600MHz PC5-44800 2Rx4 1.1V 288-PIN ECC RDIMM KIT

Tämän mallin muut versiot

5 lisää samasta mallistosta

Sama tuoteperhe, eri muisti, jäähdytin tai kellotaajuus — vertaile ennen päätöstä.

Kysymyksiä tästä tuotteesta

Does my Supermicro H14DSG-OM motherboard need all 12 DDR5 RDIMM slots filled for this 1.5TB kit to work?

The kit contains 12 modules of 128GB each. Consult the motherboard manual for supported capacities and the required DIMM population order before installation.

Will these 2Rx4 registered ECC DDR5 modules run at 5600MHz alongside any older DDR5 RDIMMs I keep in the system?

Mixing modules with different ranks, timings or voltages can prevent the memory controller from running at the rated 5600MHz CL46 1.1V. Use identical kits for full-speed operation.

How can I verify the kit is running at the rated 5600MHz CL46 1.1V after setup?

Check the memory speed, CAS latency and voltage in the BIOS or UEFI; they should show DDR5-5600 (PC5-44800), CL46 and 1.1V when the system is fully populated.

Myös tällä osastolla

Asiakkaat vertailivat myös näitä

Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.