Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.

Seuratut tuotteet Kirjaudu sisään
Two green DDR5 RDIMM modules with gold contacts and black chips, no heat spreaders

NEMIX RAM

NEMIX RAM 256GB 2x128GB DDR5 5600 CL46 2Rx4 ECC RDIMM Supermicro H14DST-F memory upgrade

SKU CH-Q4CX-TMSH4

256GB DDR5 5600 registered ECC RDIMM kit validated for Supermicro H14DST-F servers

  • Capacity256GB (2 x 128GB)
  • Type288-Pin DDR5 RDIMM
  • SpeedDDR5 5600 (PC5 44800)
  • CAS LatencyCL46
  • Voltage1.10V
  • ECCYes

Size 256GB 2X128GB

Näytä 30 muuta kokoonpanoa
  • 256 GB capacity from two 128 GB modules for maximum server density
  • DDR5 5600 speed with CL46 latency for responsive data throughput
  • Registered ECC design corrects single-bit errors to prevent silent corruption
  • 1 V operation reduces power draw across fully populated channels
  • Verified fitment for Supermicro H14DST-F motherboard with 288-pin RDIMM slots

Exact-match DDR5 server kit

The NEMIX RAM kit delivers 256GB of DDR5 5600 memory in two 128GB modules built for the Supermicro H14DST-F motherboard. Each module uses a 288-pin RDIMM form factor with registered ECC operation at 1.1V and CL46 latency. The 2Rx4 organisation matches the board's memory controller expectations so the full capacity is recognised at rated speed.

Sustained-load stability

Registered architecture buffers address and command signals, reducing electrical load on the memory controller when every slot is populated. ECC circuitry detects and corrects single-bit errors on the fly, preventing silent data corruption during long-running workloads. The modules operate at the standard 1.1V without requiring additional cooling or voltage headroom.

DDR5 interface limits

DDR5 5600 (PC5-44800) sets the maximum transfer rate this kit can achieve on the platform. Population rules and maximum supported capacity are defined by the motherboard firmware, not by the modules themselves. Buyers who need higher speeds or larger total memory must verify what the specific board revision allows before ordering.

Kohokohdat

  • 256 GB capacity from two 128 GB modules for maximum server density
  • DDR5 5600 speed with CL46 latency for responsive data throughput
  • Registered ECC design corrects single-bit errors to prevent silent corruption
  • 1 V operation reduces power draw across fully populated channels
  • Verified fitment for Supermicro H14DST-F motherboard with 288-pin RDIMM slots

Tekniset tiedot

BrandNEMIX RAM
SeriesNEMIX RAM Original Series Server Memory
ModelDDR5 ECC RDIMM Registered Server Memory
Part NumberMR44800-724K2
Capacity256GB (2 x 128GB)
Type288-Pin DDR5 RDIMM
SpeedDDR5 5600 (PC5 44800)
CAS LatencyCL46
Voltage1.10V
ECCYes
Buffered/RegisteredRegistered
Rank2Rx4
ChipsetMajor OEM Samsung, Micron, Hynix
Heat SpreaderNo
Compatible SystemSupermicro
FeaturesDDR5 ECC RDIMM Motherboard Compatible
Package Content256GB 2X128GB DDR5 5600MHz PC5-44800 2Rx4 1.1V 288-PIN ECC RDIMM KIT

Tämän mallin muut versiot

5 lisää samasta mallistosta

Sama tuoteperhe, eri muisti, jäähdytin tai kellotaajuus — vertaile ennen päätöstä.

Kysymyksiä tästä tuotteesta

How much heat and power does the 1.10V 2Rx4 registered DDR5 kit add when the server runs 24/7?

Each module operates at 1.10 volts with a 2Rx4 registered design, which reduces electrical load on the memory controller and keeps power draw and thermal output low even at full 256GB capacity.

What motherboard slot type must my Supermicro H14DST-F provide for these 288-pin RDIMMs to be recognised?

The board needs DDR5 288-pin RDIMM slots; the kit is built to the exact registered ECC specification that the H14DST-F memory controller expects.

Can I mix this 256GB 5600 CL46 registered ECC kit with other DDR5 RDIMMs of different speed or rank already installed?

Mixing is only reliable when all modules share the same 5600 speed, CL46 timing, 1.10V voltage, 2Rx4 rank and registered ECC design; otherwise the system will down-clock or fail to boot.

Myös tällä osastolla

Asiakkaat vertailivat myös näitä

Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.