Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.

Seuratut tuotteet Kirjaudu sisään

NEMIX RAM

NEMIX RAM 32GB (4x8GB) DDR4 3200 ECC UDIMM CL22 1.2V 288-pin memory upgrade

SKU CH-JEW3-0N8XF

32 GB kit of four 8 GB DDR4 ECC UDIMM modules running at 3200 MHz with CL22 latency and 1.2 V for Supermicro X12STE-F and X12STD-F motherboards

  • Capacity32GB (4 x 8GB)
  • Type288-Pin DDR4 ECC UDIMM
  • SpeedDDR4 3200 (PC4 25600)
  • CAS LatencyCL22
  • Voltage1.20V
  • ECCYes
  • ECC protects data integrity by correcting single-bit errors on the fly
  • 32 GB kit (4 × 8 GB) fills four slots for full capacity
  • DDR4-3200 CL22 1.2 V matches the board's rated speed and timing
  • 288-pin unbuffered UDIMM form factor fits Supermicro X12STE-F / X12STD-F exactly
  • Major-brand Samsung, Micron or Hynix chips ensure consistent quality and compatibility

System-specific upgrade kit

This 32GB kit contains four 8GB DDR4 ECC UDIMM modules rated at 3200 MT/s with CL22 latency at 1.2V. It is built for Supermicro X12STE-F and X12STD-F motherboards that require unbuffered ECC memory in a 288-pin DIMM form factor.

Unbuffered ECC construction

Each module uses a 1Rx8 organisation with major-brand DRAM chips and no heat spreader, keeping the profile low for dense server chassis. The 288-pin UDIMM edge connector matches the board slots exactly, so installation follows the motherboard's standard population order without adapters or registered DIMM clearance issues.

DDR4 platform limits

The DDR4 interface tops out at the 3200 MT/s data rate and 1.2V operating point specified here, so the kit cannot exceed that bandwidth on this generation. Buyers who need higher memory density per slot or registered DIMM support for larger capacities will need a platform that moves beyond DDR4 unbuffered ECC.

Kohokohdat

  • ECC protects data integrity by correcting single-bit errors on the fly
  • 32 GB kit (4 × 8 GB) fills four slots for full capacity
  • DDR4-3200 CL22 1.2 V matches the board's rated speed and timing
  • 288-pin unbuffered UDIMM form factor fits Supermicro X12STE-F / X12STD-F exactly
  • Major-brand Samsung, Micron or Hynix chips ensure consistent quality and compatibility

Tekniset tiedot

BrandNEMIX RAM
SeriesNEMIX RAM Original Series Memory
ModelDDR4 ECC Unbuffered UDIMM Memory
Part NumberME25600-818K4
Capacity32GB (4 x 8GB)
Type288-Pin DDR4 ECC UDIMM
SpeedDDR4 3200 (PC4 25600)
CAS LatencyCL22
Voltage1.20V
ECCYes
Buffered/RegisteredUnbuffered
Rank1Rx8
ChipsetMajor OEM Samsung, Micron, Hynix
Heat SpreaderNo
Compatible SystemSupermicro
FeaturesDDR4 ECC Unbuffered UDIMM Motherboard Compatible
Package Content32GB 4X8GB DDR4 3200MHz PC4-25600 1Rx8 1.2V 288-PIN ECC UDIMM KIT

Tämän mallin muut versiot

5 lisää samasta mallistosta

Sama tuoteperhe, eri muisti, jäähdytin tai kellotaajuus — vertaile ennen päätöstä.

Kysymyksiä tästä tuotteesta

What DDR4 standard and speed does this 32GB kit use?

This kit uses DDR4 3200 (PC4-25600) with CL22 timing and 1.20V voltage.

What physical slot and form factor are required for these modules?

The modules are 288-pin unbuffered ECC UDIMMs; they need standard desktop DIMM slots that accept unbuffered ECC memory.

How should the four 8GB sticks be installed on a Supermicro X12STE-F or X12STD-F board?

Install all four modules following the motherboard manual's population order for 4 DIMMs; a common mistake is skipping the prescribed slot sequence, which can prevent full capacity recognition.

Myös tällä osastolla

Asiakkaat vertailivat myös näitä

Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.