Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.

Seuratut tuotteet Kirjaudu sisään
Twelve green DDR5 RDIMM modules in anti-static tray

NEMIX RAM

NEMIX RAM DDR5 5600 384GB 12x32GB ECC RDIMM CL46 1.1V Supermicro H14DSG-O-CPU

SKU CH-XR4A-VW8RV

A 384 GB DDR5 ECC RDIMM kit with twelve 32 GB modules at 5600 MHz, CL46, 1.1 V, 2Rx8, for Supermicro H14DSG-O-CPU

  • Capacity384GB (12 x 32GB)
  • Type288-Pin DDR5 RDIMM
  • SpeedDDR5 5600 (PC5 44800)
  • CAS LatencyCL46
  • Voltage1.10V
  • ECCYes

Size 384GB 12X32GB

Näytä 30 muuta kokoonpanoa
  • 384 GB total capacity across 12 matched 32 GB modules
  • DDR5 5600 speed with CL46 latency runs at rated frequency
  • Registered ECC architecture corrects single-bit errors and stabilises full population
  • 1 V operation matches the motherboard's memory-controller specification
  • 288-pin RDIMM form factor fits the Supermicro H14DSG-O-CPU slots

384GB DDR5-5600 ECC RDIMM kit

This 12-module kit delivers 384GB of DDR5-5600 registered ECC memory built for the Supermicro H14DSG-O-CPU motherboard. Each 32GB 2Rx8 DIMM runs at 1.1V with CL46 timing and uses the 288-pin RDIMM form factor the board requires. The registered architecture allows every slot to run fully populated at rated speed.

Suited for servers needing maximum registered ECC

Administrators populating all memory channels on a compatible Supermicro platform gain the full 384GB at DDR5-5600 without down-clocking. Builders using consumer UDIMM or SODIMM slots cannot install these modules, and workloads that do not require ECC error correction will not benefit from the registered buffer overhead.

Sustained load stability from registered ECC design

Under continuous operation the registered buffer reduces electrical load on the memory controller so all twelve DIMMs maintain DDR5-5600 throughput. ECC corrects single-bit errors in real time, preventing silent data corruption that can accumulate during long compute runs. The 1.1V operating voltage keeps power draw consistent across the fully populated array.

Kohokohdat

  • 384 GB total capacity across 12 matched 32 GB modules
  • DDR5 5600 speed with CL46 latency runs at rated frequency
  • Registered ECC architecture corrects single-bit errors and stabilises full population
  • 1 V operation matches the motherboard's memory-controller specification
  • 288-pin RDIMM form factor fits the Supermicro H14DSG-O-CPU slots

Tekniset tiedot

BrandNEMIX RAM
SeriesNEMIX RAM Original Series Server Memory
ModelDDR5 ECC RDIMM Registered Server Memory
Part NumberMR44800-328K12
Capacity384GB (12 x 32GB)
Type288-Pin DDR5 RDIMM
SpeedDDR5 5600 (PC5 44800)
CAS LatencyCL46
Voltage1.10V
ECCYes
Buffered/RegisteredRegistered
Rank2Rx8
ChipsetMajor OEM Samsung, Micron, Hynix
Heat SpreaderNo
Compatible SystemSupermicro
FeaturesDDR5 ECC RDIMM Motherboard Compatible
Package Content384GB 12X32GB DDR5 5600MHz PC5-44800 2Rx8 1.1V 288-PIN ECC RDIMM KIT

Tämän mallin muut versiot

5 lisää samasta mallistosta

Sama tuoteperhe, eri muisti, jäähdytin tai kellotaajuus — vertaile ennen päätöstä.

Kysymyksiä tästä tuotteesta

Does the Supermicro H14DSG-O-CPU motherboard have twelve DDR5 RDIMM slots so the full 384 GB kit can be installed?

The kit contains twelve 32 GB modules. The H14DSG-O-CPU must provide twelve 288-pin DDR5 RDIMM slots and support 384 GB total capacity for the kit to populate fully.

Can I keep my existing DDR5 4800 RDIMMs and add this DDR5 5600 kit to the same server?

Mixing DDR5 4800 and DDR5 5600 RDIMMs will force all modules to run at the lower 4800 speed and may violate the motherboard's population rules for registered ECC memory.

After installation, how do I confirm the kit runs at DDR5 5600 CL46 1.1 V with ECC active?

Enter the BIOS or use a tool like dmidecode to verify each DIMM shows 5600 MT/s, CL46 timing, 1.1 V operation, registered ECC type and the full 384 GB capacity.

Myös tällä osastolla

Asiakkaat vertailivat myös näitä

Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.