Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.

Seuratut tuotteet Kirjaudu sisään
Green bare circuit board DDR5 64GB 288-pin RDIMM memory module

NEMIX RAM

NEMIX RAM DDR5 5600 64GB ECC Registered RDIMM 2Rx4 CL46 1.1V Supermicro H14DSH memory upgrade

SKU CH-8RT8-35H4A

64 GB DDR5-5600 ECC registered RDIMM, 2Rx4 CL46 1.1 V, validated for Supermicro H14DSH servers

  • Capacity64GB
  • Type288-Pin DDR5 RDIMM
  • SpeedDDR5 5600 (PC5 44800)
  • CAS LatencyCL46
  • Voltage1.10V
  • ECCYes

Size 64GB

Näytä 30 muuta kokoonpanoa
  • 64 GB capacity lets your Supermicro H14DSH run fully populated at rated speed
  • Registered ECC architecture offloads the memory controller and corrects single-bit errors on the fly
  • DDR5 5600 PC5-44800 CL46 timing matches the board's exact rank, voltage and timing expectations
  • 1 V operation reduces power draw while maintaining stability across all slots
  • 288-pin RDIMM form factor fits the H14DSH memory population rules without adapters

64 GB DDR5 ECC RDIMM for Supermicro H14DSH

This 64 GB DDR5 5600 module is an exact-match registered ECC upgrade built for the Supermicro H14DSH motherboard. It runs at 1.1 V with CL46 latency and a 2Rx4 rank layout so the memory controller recognises full capacity at rated speed. Targeted at administrators expanding server memory in a validated configuration.

Install in approved slots

The 288-pin RDIMM seats like any registered DIMM, but the board requires a specific population order that the manual defines. Using UDIMM or SODIMM modules will not fit and mixing ranks can prevent the system from posting. Follow the vendor guide slot-by-slot to avoid a no-boot condition.

Confirm supported capacity

Check the motherboard manual for maximum supported capacity per slot and the approved DIMM population sequence. The H14DSH may limit total memory or require a specific fill order across channels. Buyers who need more than the board allows or a different rank configuration cannot use this module.

Kohokohdat

  • 64 GB capacity lets your Supermicro H14DSH run fully populated at rated speed
  • Registered ECC architecture offloads the memory controller and corrects single-bit errors on the fly
  • DDR5 5600 PC5-44800 CL46 timing matches the board's exact rank, voltage and timing expectations
  • 1 V operation reduces power draw while maintaining stability across all slots
  • 288-pin RDIMM form factor fits the H14DSH memory population rules without adapters

Tekniset tiedot

BrandNEMIX RAM
SeriesNEMIX RAM Original Series Server Memory
ModelDDR5 ECC RDIMM Registered Server Memory
Part NumberMR44800-924K1
Capacity64GB
Type288-Pin DDR5 RDIMM
SpeedDDR5 5600 (PC5 44800)
CAS LatencyCL46
Voltage1.10V
ECCYes
Buffered/RegisteredRegistered
Rank2Rx4
ChipsetMajor OEM Samsung, Micron, Hynix
Heat SpreaderNo
Compatible SystemSupermicro
FeaturesDDR5 ECC RDIMM Motherboard Compatible
Package Content64GB DDR5 5600MHz PC5-44800 2Rx4 1.1V 288-PIN ECC RDIMM KIT

Tämän mallin muut versiot

5 lisää samasta mallistosta

Sama tuoteperhe, eri muisti, jäähdytin tai kellotaajuus — vertaile ennen päätöstä.

Kysymyksiä tästä tuotteesta

How do I confirm the 64GB DDR5 5600 RDIMM is running at 5600 MT/s with CL46 after installing it in my Supermicro H14DSH?

Enter the BIOS on first boot and verify the memory speed reads 5600 MT/s (PC5-44800) with CAS latency 46; the registered ECC design and 1.10 V rating ensure the controller recognises the full 64 GB at its rated timing when populated per the motherboard manual.

What ships in the box and do I need any extra brackets, cables or cooling for this 288-pin RDIMM?

The package contains the 64 GB DDR5 5600 CL46 2Rx4 1.10 V 288-pin ECC Registered RDIMM kit only; no heat spreader is fitted and no additional brackets, cables or cooling accessories are required for installation.

My H14DSH manual lists several DDR5 capacities — how do I know this 64 GB 2Rx4 module is the right one to pick?

Choose this module when your configuration calls for a 64 GB Registered ECC DDR5-5600 DIMM with 2Rx4 organisation, 1.10 V operation and CL46 timing; it matches the exact rank, voltage and latency the board expects for full-capacity, full-speed operation.

Myös tällä osastolla

Asiakkaat vertailivat myös näitä

Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.