Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.

Seuratut tuotteet Kirjaudu sisään

NEMIX RAM

NEMIX RAM DDR5 5600 CL46 384GB (6x64GB) ECC Registered RDIMM Supermicro H14DST-FL memory upgrade

SKU CH-H1F3-7ENZN

A 384GB kit of six 64GB DDR5 5600 CL46 ECC registered RDIMMs at 1.1V, verified for the Supermicro H14DST-FL motherboard

  • Capacity384GB (6 x 64GB)
  • Type288-Pin DDR5 RDIMM
  • SpeedDDR5 5600 (PC5 44800)
  • CAS LatencyCL46
  • Voltage1.10V
  • ECCYes
  • 384 GB total capacity from six 64 GB modules
  • DDR5 5600 speed with CL46 latency for rated throughput
  • Registered ECC architecture corrects single-bit errors on the fly
  • 1 V operation matches the motherboard's memory controller spec
  • 288-pin RDIMM form factor verified for Supermicro H14DST-FL

Capacity and purpose

This 384 GB kit contains six 64 GB DDR5 registered ECC RDIMMs built for the Supermicro H14DST-FL motherboard. It targets servers and workstations that require maximum supported memory capacity with error correction and registered signalling.

Sustained-load behaviour

Registered buffering reduces electrical load on the memory controller so all slots can run fully populated at the rated 5600 MT/s speed. ECC corrects single-bit errors on the fly to prevent silent data corruption during continuous operation. The modules operate at 1.1 V with CL46 latency.

Pre-order checks

Verify the motherboard manual for approved DIMM population order and maximum capacity per channel before ordering. Confirm the system requires 288-pin registered RDIMMs rather than unbuffered or SO-DIMM form factors. Ensure the BIOS version supports the installed capacity and rank configuration.

Kohokohdat

  • 384 GB total capacity from six 64 GB modules
  • DDR5 5600 speed with CL46 latency for rated throughput
  • Registered ECC architecture corrects single-bit errors on the fly
  • 1 V operation matches the motherboard's memory controller spec
  • 288-pin RDIMM form factor verified for Supermicro H14DST-FL

Tekniset tiedot

BrandNEMIX RAM
SeriesNEMIX RAM Original Series Server Memory
ModelDDR5 ECC RDIMM Registered Server Memory
Part NumberMR44800-924K6
Capacity384GB (6 x 64GB)
Type288-Pin DDR5 RDIMM
SpeedDDR5 5600 (PC5 44800)
CAS LatencyCL46
Voltage1.10V
ECCYes
Buffered/RegisteredRegistered
Rank2Rx4
ChipsetMajor OEM Samsung, Micron, Hynix
Heat SpreaderNo
Compatible SystemSupermicro
FeaturesDDR5 ECC RDIMM Motherboard Compatible
Package Content384GB 6X64GB DDR5 5600MHz PC5-44800 2Rx4 1.1V 288-PIN ECC RDIMM KIT

Tämän mallin muut versiot

5 lisää samasta mallistosta

Sama tuoteperhe, eri muisti, jäähdytin tai kellotaajuus — vertaile ennen päätöstä.

Kysymyksiä tästä tuotteesta

How much power does the 1.1 V DDR5 kit draw when the server runs continuously?

Each module operates at 1.10 V, the standard DDR5 voltage, so total power scales with the 384 GB capacity and 5600 MT/s data rate under load.

What motherboard slot and population rules must my Supermicro H14DST-FL already support for this 6 × 64 GB kit?

The board needs six 288-pin RDIMM slots wired for registered ECC memory and a population sequence that accepts 2Rx4 modules in every channel.

Will the registered ECC RDIMMs run at their rated 5600 speed if I keep older DDR5 DIMMs in the remaining slots?

Mixing ranks or speeds usually forces the memory controller to downclock all channels to the slowest common JEDEC setting, so full 5600 MT/s operation is not guaranteed.

Myös tällä osastolla

Asiakkaat vertailivat myös näitä

Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.