A-Tech
A-Tech 8GB DDR4 3200 Desktop RAM 1Rx16 1.2V
8GB DDR4 3200 desktop module, 1Rx16 unbuffered at 1.2V for AMD and Intel systems
- Capacity8GB
- SpeedDDR4 3200 (PC4 25600)
- Tested Frequency3200
- Voltage1.20V
- ECCNo
- Buffered/RegisteredUnbuffered
- 8GB capacity handles heavier multitasking with ease
- DDR4 3200 speed moves data at PC4-25600 rates
- 2V operation keeps power draw low
- 288-pin DIMM fits standard desktop slots
- Non-ECC unbuffered design suits consumer motherboards
8GB DDR4 3200 Desktop Module
This 8GB DDR4 module runs at 3200MHz with a 1.20V operating voltage. It is an unbuffered, non-ECC DIMM built for desktop systems needing a straightforward memory increase. The single-rank 1Rx16 organisation keeps the design simple for broad platform compatibility.
Installation notes and common issues
The 288-pin DIMM slots into any standard DDR4 desktop socket without tools or configuration changes. Most problems arise when the motherboard cannot train at the rated 3200 speed and falls back to a lower JEDEC frequency. Mixing this stick with modules of different rank structure or voltage can also prevent the system from posting.
DDR4 practical limits
DDR4 tops out at the 3200 data rate used by this module, so no higher standard speed exists for this generation. The 1.2V baseline leaves little headroom for manual overclocking without raising voltage. Capacity per stick is limited by current density, so larger upgrades require additional slots rather than denser single modules.
Points forts
- 8GB capacity handles heavier multitasking with ease
- DDR4 3200 speed moves data at PC4-25600 rates
- 2V operation keeps power draw low
- 288-pin DIMM fits standard desktop slots
- Non-ECC unbuffered design suits consumer motherboards
Caractéristiques
| Brand | A-Tech |
|---|---|
| Capacity | 8GB |
| Speed | DDR4 3200 (PC4 25600) |
| Tested Frequency | 3200 |
| Voltage | 1.20V |
| ECC | No |
| Buffered/Registered | Unbuffered |
| Recommend Use | AMD & Intel Compatible |
Questions sur cet article
Will this 8 GB DDR4 3200 module work in a desktop that uses a 288-pin DIMM slot?
Yes, the stick is a standard 288-pin DDR4 UDIMM, so it fits any desktop board that accepts DDR4 DIMMs.
Can I add this stick alongside my existing 1.2 V DDR4 memory without voltage conflicts?
The module runs at the standard 1.2 V, matching the voltage of most modern DDR4 kits, so mixing is electrically safe.
Is the 1Rx16 organisation compatible with a motherboard that lists 1Rx8 or 2Rx8 support?
Rank and chip organisation are handled by the memory controller; most current desktop chipsets accept 1Rx16 modules alongside 1Rx8 or 2Rx8 DIMMs.
Également dans ce rayon
Les clients ont aussi comparé
Même rayon, même caisse — huit monnaies et un taux bloqué 30 minutes.
PrimoChill Praxis Wetbench Open-Air Test Bench 461.8mm
- Open-Air
SilverStone Technology Strider 1200W 80 Plus Platinum Modular Power Supply
- ATX Mid Tower
- 1200W



