Computer Memory Solutions 16GB DDR4 2400MHz SODIMM memory upgrade C107

Targeted 16 GB DDR4 laptop upgrade

This 16 GB DDR4 SODIMM module is built for specific Acer Aspire 5 and Aspire 7 models listed by the manufacturer. It suits owners of those notebooks who need to add or replace memory without guessing compatibility. The stick is unbuffered, non-ECC and runs at 1.2 V, matching the electrical requirements of the supported platforms. Buyers with other laptop brands or desktop systems cannot use this module.

Speed and pin count decide fit

The module operates at DDR4 2400 (PC4-19200) with a CAS latency of 17 and a 260-pin SO-DIMM edge connector. These three figures — speed, latency and pin count — determine whether the part will be recognised and run at the correct frequency. The system maximum is 32 GB across two sockets, so a single 16 GB stick leaves room for a matching second module if dual-channel performance is desired. Systems limited to lower memory speeds or different pin layouts will not accept this upgrade.

Straightforward slot insertion

Installation consists of opening the laptop's memory compartment, aligning the notch on the 260-pin edge connector and pressing the stick firmly until the retention clips click. No tools beyond a small screwdriver for the access panel are required. The most common issue is inserting the module at an angle or not seating it fully, which causes the system to show no new memory or fail to boot. Mixing this stick with existing modules of different speeds will force all memory to run at the slowest installed speed.