DELL
DELL 3.84TB 24Gbps SAS RI TLC 2.5 SSD KPM7XRUG3T84 CPO
Provides 3.84 TB of read-intensive SAS storage in a 2.5-inch form factor for compatible Dell PowerEdge servers
- InterfaceSAS
- 84 TB capacity supports large read-intensive workloads
- 24 Gbps SAS interface delivers high-throughput data transfer
- Read-intensive TLC design optimised for endurance in server environments
- 5-inch form factor fits standard enterprise drive bays
- Validated across Dell PowerEdge servers and storage arrays
Capacity and interface
This Dell enterprise SSD provides 3.84TB of storage over a 24Gbps SAS interface. It uses TLC flash tuned for read-intensive workloads in 2.5-inch drive bays. The drive suits servers that need high-capacity, low-latency access to frequently read data.
Thermals and power
The SSD is designed for standard enterprise chassis airflow and typical SAS power envelopes. Normal operation stays within the thermal limits expected for 2.5-inch SAS drives in compatible PowerEdge servers. Firmware is updated to the latest vendor release before shipment.
Compatibility list
The drive is validated for a wide range of Dell PowerEdge rack, tower, modular and storage platforms including R640, R740, R750, R760, MX740c, MX750C, ME4024 and ME5024 models. Buyers whose servers are not on this qualification list should verify support with their hardware vendor before purchase.
Points forts
- 84 TB capacity supports large read-intensive workloads
- 24 Gbps SAS interface delivers high-throughput data transfer
- Read-intensive TLC design optimised for endurance in server environments
- 5-inch form factor fits standard enterprise drive bays
- Validated across Dell PowerEdge servers and storage arrays
Caractéristiques
| Brand | Dell |
|---|---|
| Model | KPM7XRUG3T84, MT0R5 |
| Interface | SAS |
Questions sur cet article
How is the 2.5-inch SAS SSD installed in a PowerEdge R750, and which step is often missed?
Slide the drive into the hot-plug bay until the carrier clicks, then press the release latch to lock it; the step often missed is fully engaging the latch so the SAS connector seats on the backplane.
What maintenance will the 3.84TB RI TLC drive need later?
No scheduled maintenance is required; the drive relies on internal wear-levelling and error correction, and replacement is only needed if SMART attributes report media exhaustion or a controller flags a predictive failure.
What limit appears first on the 24Gbps SAS link during sustained reads?
The 24Gbps SAS interface bandwidth ceiling is reached before the TLC NAND saturates, so sequential throughput tops out at the link rate rather than the flash speed.
Également dans ce rayon
Les clients ont aussi comparé
Même rayon, même caisse — huit monnaies et un taux bloqué 30 minutes.



