myVolts
myVolts HRUW-150W-24V 100-240VAC AC-DC Power Supply
Ultra-thin IP67 waterproof 150W AT switching supply delivers 24V from 100-240VAC 50/60Hz input
- TypeAT
- 150 W output powers demanding 24 V systems
- Universal 100-240 VAC input works worldwide
- IP67 rating protects against dust and water immersion
- Ultra-thin profile fits tight installation spaces
- Anodized wear-resistant surface maintains performance over time
Ultra-thin waterproof AC-DC power supply
The myVolts HRUW-150W-24V converts 100-240VAC mains electricity into a regulated 24 V DC output at up to 150 W. Its IP67-rated enclosure and ultra-thin profile allow installation in tight or damp locations where conventional units would not fit. An anodised, wear-resistant surface protects the housing during handling and long-term use.
Suited for builders needing a compact sealed supply
Engineers integrating LED lighting, industrial sensors or embedded controllers in outdoor cabinets or marine environments will value the waterproof construction and simple wiring. Installations that require an ATX form factor, modular cabling or active PFC should look elsewhere because this unit uses an AT-type design with fixed leads.
150 W maximum output power decides fit
The 150 W rating sets the hard limit for total connected load; exceeding it will trigger protection or cause shutdown. Verify that the combined draw of all 24 V devices stays below this figure before committing to the HRUW-150W-24V.
Points forts
- 150 W output powers demanding 24 V systems
- Universal 100-240 VAC input works worldwide
- IP67 rating protects against dust and water immersion
- Ultra-thin profile fits tight installation spaces
- Anodized wear-resistant surface maintains performance over time
Caractéristiques
| Type | AT |
|---|
Questions sur cet article
What AC input range and frequency does the HRUW-150W-24V accept?
It accepts 100-240 VAC at 50/60 Hz, so it works on mains worldwide without a voltage switch.
What mounting provision does the ultra-thin IP67 unit have?
The anodised aluminium case includes integrated mounting ears for direct screw fixing to a flat surface.
How do you install the AT-type supply and what step is often missed?
Connect the three AC wires to L, N and ground, then the DC output to your load; the step often missed is tightening the waterproof gland nuts to keep the IP67 seal.
Également dans ce rayon
Les clients ont aussi comparé
Même rayon, même caisse — huit monnaies et un taux bloqué 30 minutes.
Silverstone Decathlon R Gold 750W ATX 3.0 power supply
Silverstone Technology FA311-B FARA 311 Micro-ATX PC case
- Micro ATX



