RIMLANCE
RIMLANCE 16GB (2x8GB) DDR3 1333 PC3-10600 1.35V UDIMM 2RX8 desktop RAM
A 16 GB dual-channel DDR3 kit running at 1333 MHz with CL9 latency and 1.35 V low-voltage operation
- Capacity16GB (2 x 8GB)
- SpeedDDR3 1333 (PC3 10600)
- CAS LatencyCL9
- ECCNo
- Buffered/RegisteredUnbuffered
- Multi-channel KitDual Channel Kit
- 16 GB dual-channel kit for smoother multitasking
- DDR3 1333 PC3-10600 CL9 for responsive data access
- Low 1.35 V operation cuts power draw and heat
- 240-pin UDIMM fits standard desktop DIMM slots
- Unbuffered non-ECC design for broad consumer compatibility
16 GB DDR3 Dual-Channel Kit
This 16 GB kit contains two 8 GB unbuffered DIMMs built for desktop systems that use DDR3 memory. The modules run at 1333 MT/s with a CAS latency of 9 and operate at 1.35 V. They are designed for general multitasking and everyday workloads.
Upgrade from 4 GB or 8 GB DDR3
Replacing a smaller DDR3 kit with this 16 GB dual-channel set adds headroom for heavier multitasking and memory-intensive applications. The jump is worthwhile when your current installation leaves little free memory during typical use.
Check DDR3 motherboard compatibility
Verify that your motherboard accepts 240-pin DDR3 UDIMMs and supports 1.35 V low-voltage operation. Confirm the board can run memory at 1333 MT/s and that two slots are free for the dual-channel pair.
Points forts
- 16 GB dual-channel kit for smoother multitasking
- DDR3 1333 PC3-10600 CL9 for responsive data access
- Low 1.35 V operation cuts power draw and heat
- 240-pin UDIMM fits standard desktop DIMM slots
- Unbuffered non-ECC design for broad consumer compatibility
Caractéristiques
| Brand | RIMLANCE |
|---|---|
| Model | RUD10600LD8C2K16 |
| Capacity | 16GB (2 x 8GB) |
| Speed | DDR3 1333 (PC3 10600) |
| CAS Latency | CL9 |
| ECC | No |
| Buffered/Registered | Unbuffered |
| Multi-channel Kit | Dual Channel Kit |
| Chipset | Major Brand Chipset |
Questions sur cet article
Will the 240-pin DDR3 modules fit my desktop motherboard?
Yes, each 8 GB stick uses the standard 240-pin DDR3 form factor that matches any desktop board with DDR3 slots.
What is the correct way to seat the two sticks for dual-channel operation?
Insert both modules into the same-coloured DIMM slots — usually slots one and three — pressing firmly until the retention clips click on both ends.
Does the 1.35 V rating mean I will need to replace the modules sooner?
No, the low 1.35 V operation reduces heat and stress, so the kit should last the life of a typical DDR3 system without degradation.
Également dans ce rayon
Les clients ont aussi comparé
Même rayon, même caisse — huit monnaies et un taux bloqué 30 minutes.
PrimoChill Praxis Wetbench Open-Air Test Bench 461.8mm
- Open-Air
SilverStone Technology Strider 1200W 80 Plus Platinum Modular Power Supply
- ATX Mid Tower
- 1200W



