RIMLANCE
RIMLANCE RUD12800LD8C2K8 8GB (2x4GB) DDR3 1600 CL11 1.35V Desktop RAM
A dual-channel kit of two 4 GB DDR3 UDIMMs running at 1600 MHz with CL11 latency at 1.35 V
- Capacity8GB (2 x 4GB)
- SpeedDDR3 1600 (PC3 12800)
- CAS LatencyCL11
- ECCNo
- Buffered/RegisteredUnbuffered
- ChipsetMajor Brand Chipset
- 8GB dual-channel kit boosts multitasking headroom with two 4GB modules
- 1600MHz DDR3 speed delivers responsive throughput for everyday workloads
- CL11 latency keeps data access snappy during heavy use
- 35V low-voltage operation reduces power draw and heat
- 240-pin unbuffered non-ECC DIMMs install straight into standard desktop slots
Ready-to-install DDR3 kit
This RIMLANCE kit supplies two unbuffered 4 GB DIMMs for a total of 8 GB. The modules are standard 240-pin desktop UDIMMs built with major-brand chips. They are designed for straightforward upgrades on DDR3 platforms. No ECC or registered buffering is present.
1600 MHz CL11 at 1.35 V
The memory runs at a data rate of 1600 MHz, labelled PC3-12800, with a CAS latency of 11. Operation is specified at 1.35 volts, lower than the traditional 1.5 V DDR3 standard. This combination of speed, timing and voltage is the key compatibility check for the target system.
Low-voltage thermals and quiet operation
Because the kit operates at 1.35 V, power draw and heat output are reduced compared with standard-voltage DDR3. The modules use passive cooling only, so they add no fan noise to the build. Typical desktop workloads keep temperatures well within normal DDR3 limits.
Points forts
- 8GB dual-channel kit boosts multitasking headroom with two 4GB modules
- 1600MHz DDR3 speed delivers responsive throughput for everyday workloads
- CL11 latency keeps data access snappy during heavy use
- 35V low-voltage operation reduces power draw and heat
- 240-pin unbuffered non-ECC DIMMs install straight into standard desktop slots
Caractéristiques
| Brand | RIMLANCE |
|---|---|
| Model | RUD12800LD8C2K8 |
| Capacity | 8GB (2 x 4GB) |
| Speed | DDR3 1600 (PC3 12800) |
| CAS Latency | CL11 |
| ECC | No |
| Buffered/Registered | Unbuffered |
| Chipset | Major Brand Chipset |
Questions sur cet article
Will this kit work in a motherboard that only accepts 1.5 V DDR3 modules?
The modules are rated for 1.35 V operation; a board limited to 1.5 V may not boot or may run them out of spec.
My board has four DIMM slots — can I add this kit alongside two existing 4 GB sticks?
Yes, the two 4 GB modules fill two slots and leave the other two free for your current memory.
What does the CL11 figure mean for everyday use?
It is the CAS latency in clock cycles; lower numbers give slightly quicker response, and CL11 is standard for 1600 MHz DDR3.
Également dans ce rayon
Les clients ont aussi comparé
Même rayon, même caisse — huit monnaies et un taux bloqué 30 minutes.
PrimoChill Praxis Wetbench Open-Air Test Bench 461.8mm
- Open-Air
SilverStone Technology Strider 1200W 80 Plus Platinum Modular Power Supply
- ATX Mid Tower
- 1200W



