RIMLANCE
RIMLANCE RUD25600D8C2K32 32GB (2x16GB) DDR4 3200 CL22 desktop RAM
A 32 GB dual-channel DDR4 kit with two 16 GB UDIMMs running at 3200 MT/s CL22 on 1.2 V
- Capacity32GB (2 x 16GB)
- Type288-Pin PC RAM
- SpeedDDR4 3200 (PC4 25600)
- CAS LatencyCL22
- ECCNo
- Buffered/RegisteredUnbuffered
- 32 GB total capacity with two 16 GB modules
- 3200 MHz DDR4 speed rated at PC4-25600
- Low 1.2 V operation for efficient power use
- CL22 CAS latency for responsive timing
- 288-pin unbuffered DIMM fits standard desktop slots
Kit capacity and target use
This 32 GB kit contains two 16 GB DDR4 UDIMMs rated at 3200 MT/s with CL22 latency. It is aimed at desktop builders who need a straightforward capacity upgrade for everyday multitasking and general workloads. The modules run at 1.2 V and use a standard 288-pin layout.
Who it fits and who should look elsewhere
The unbuffered, non-ECC design suits typical consumer motherboards that accept DDR4 UDIMMs. It is not intended for systems that require registered or ECC memory, nor for platforms limited to lower DDR4 speeds or different pin counts. Buyers needing higher frequencies, tighter timings or larger single-module densities should consider other options.
Installation ease and common pitfalls
Installation follows the usual DIMM slot procedure: align the notch, press firmly until the retention clips click, and ensure both modules seat in the correct channels for dual-channel operation. The most frequent issues are mismatched BIOS settings that leave the kit at a lower speed, mixing with dissimilar modules that prevent XMP from engaging, and forgetting to fully latch both ends of each stick.
Points forts
- 32 GB total capacity with two 16 GB modules
- 3200 MHz DDR4 speed rated at PC4-25600
- Low 1.2 V operation for efficient power use
- CL22 CAS latency for responsive timing
- 288-pin unbuffered DIMM fits standard desktop slots
Caractéristiques
| Brand | RIMLANCE |
|---|---|
| Model | RUD25600D8C2K32 |
| Capacity | 32GB (2 x 16GB) |
| Type | 288-Pin PC RAM |
| Speed | DDR4 3200 (PC4 25600) |
| CAS Latency | CL22 |
| ECC | No |
| Buffered/Registered | Unbuffered |
| Chipset | Major Brand Chipset |
Questions sur cet article
Does my motherboard need a 288-pin DDR4 slot to use these modules?
Yes, each stick is a 288-pin UDIMM, so the board must provide DDR4 slots.
Will these 3200 MT/s CL22 sticks down-clock to match older DDR4 modules I keep installed?
They will run at the highest common speed the motherboard negotiates, typically the lowest rated module in the system.
How can I confirm the kit is running at 3200 MT/s after installation?
Check the memory frequency in BIOS or a system utility such as CPU-Z; it should report 3200 MT/s when XMP or the equivalent profile is enabled.
Également dans ce rayon
Les clients ont aussi comparé
Même rayon, même caisse — huit monnaies et un taux bloqué 30 minutes.
PrimoChill Praxis Wetbench Open-Air Test Bench 461.8mm
- Open-Air
SilverStone Technology Strider 1200W 80 Plus Platinum Modular Power Supply
- ATX Mid Tower
- 1200W



