SK hynix
SK hynix HMA451U6AFR8N-TF 8GB (2x4GB) DDR4-2133 CL15 desktop RAM
Two 4 GB unbuffered DDR4 DIMMs running at 2133 MT/s with CL15 latency and 1.20 V
- Capacity8GB (2 x 4GB)
- SpeedDDR4 2133 (PC4 17000)
- CAS LatencyCL15
- Voltage1.20V
- ECCNo
- Buffered/RegisteredUnbuffered
- 8 GB total capacity from two 4 GB modules
- DDR4-2133 speed at PC4-17000 bandwidth
- CL15 latency for responsive desktop performance
- 20 V operation reduces system power draw
- 288-pin unbuffered DIMMs fit standard desktop slots
8 GB dual-channel DDR4 kit
This SK hynix kit provides 8 GB of DDR4 desktop memory in two 4 GB modules. It runs at DDR4-2133 with a CAS latency of 15 and operates at 1.20 V. The unbuffered, non-ECC DIMMs are suited for standard desktop builds and upgrades.
Check 288-pin DDR4 slots and voltage
Verify that your motherboard has free 288-pin DDR4 slots and supports 1.20 V operation. The board must accept unbuffered, non-ECC modules at DDR4-2133. Confirm the maximum memory capacity and slot population rules in the motherboard manual before ordering.
Matched pair enables dual-channel mode
The two modules are packaged together as a matched set, allowing the memory controller to run in dual-channel mode when installed in the correct slots. This configuration can increase memory throughput compared with a single module of the same total capacity. No additional software or accessories are included.
Points forts
- 8 GB total capacity from two 4 GB modules
- DDR4-2133 speed at PC4-17000 bandwidth
- CL15 latency for responsive desktop performance
- 20 V operation reduces system power draw
- 288-pin unbuffered DIMMs fit standard desktop slots
Caractéristiques
| Brand | Hynix |
|---|---|
| Series | Desktop Memory |
| Model | HMA451U6AFR8N-TF |
| Capacity | 8GB (2 x 4GB) |
| Speed | DDR4 2133 (PC4 17000) |
| CAS Latency | CL15 |
| Voltage | 1.20V |
| ECC | No |
| Buffered/Registered | Unbuffered |
Questions sur cet article
Will these two 4 GB sticks fit a standard desktop motherboard?
Yes, each module is a 288-pin DIMM built for DDR4 desktop slots, so they install in any board that accepts DDR4 memory.
What do the CL15 and 2133 figures mean for everyday use?
CL15 is the CAS latency timing and 2133 MT/s is the data rate; together they set the module's baseline speed and response time at the standard 1.20 V.
Is any special configuration needed to run the kit at its rated speed?
The kit is rated for DDR4-2133 at CL15 using the standard 1.20 V; most motherboards will apply those settings automatically on first boot.
Également dans ce rayon
Les clients ont aussi comparé
Même rayon, même caisse — huit monnaies et un taux bloqué 30 minutes.
PrimoChill Praxis Wetbench Open-Air Test Bench 461.8mm
- Open-Air
SilverStone Technology Strider 1200W 80 Plus Platinum Modular Power Supply
- ATX Mid Tower
- 1200W



