SK hynix
SK hynix HMT42GR7BFR4A-PB DDR3L-1600 16GB CL11 ECC Registered 240-Pin Server Memory
16 GB DDR3L-1600 ECC registered server memory with CL11 latency and 1.35 V operation
- Capacity16GB
- Type240-Pin DDR3 SDRAM
- SpeedDDR3 1600 (PC3 12800)
- CAS LatencyCL11
- 16 GB capacity supports demanding server workloads
- DDR3L-1600 speed delivers 12800 MT/s data rate
- CL11 latency ensures responsive memory access
- ECC registered design protects data integrity
- 240-pin DDR3L form factor fits standard server slots
16GB DDR3L-1600 ECC Registered DIMM
This 16GB DDR3L module runs at 1600 MHz with a CAS latency of CL11. It is built with Hynix dual-rank x4 chips and operates at 1.35V. The registered design adds a buffer to reduce electrical load on the memory controller.
Servers needing registered DDR3L memory
This module suits systems that require 240-pin DDR3L ECC registered DIMMs at PC3-12800 speed. It is not for desktop boards that accept only unbuffered non-ECC memory. It is also not for platforms limited to DDR3L single-rank configurations.
240-pin DDR3L registered form factor
The 240-pin registered DDR3L interface determines whether this DIMM fits the target server. Verify that the platform supports registered ECC modules at 1.35V before purchase.
Points forts
- 16 GB capacity supports demanding server workloads
- DDR3L-1600 speed delivers 12800 MT/s data rate
- CL11 latency ensures responsive memory access
- ECC registered design protects data integrity
- 240-pin DDR3L form factor fits standard server slots
Caractéristiques
| Capacity | 16GB |
|---|---|
| Type | 240-Pin DDR3 SDRAM |
| Speed | DDR3 1600 (PC3 12800) |
| CAS Latency | CL11 |
Questions sur cet article
Will the 1.35 V DDR3L voltage limit headroom when the module runs continuously at 1600 MT/s?
The module is specified at 1.35 V for DDR3L-1600 operation, so sustained full-speed use stays within the rated voltage envelope.
How much heat does the registered 16 GB dual-rank stick produce inside a crowded 240-pin server chassis?
Registered DDR3L at 1.35 V typically runs cooler than standard 1.5 V DDR3, reducing thermal load in dense 240-pin configurations.
Does my motherboard need to support ECC and registered DDR3L to use this 16 GB CL11 module?
Yes — the board must accept DDR3L registered ECC memory at 1600 MT/s with CL11 timing for the module to function correctly.
Également dans ce rayon
Les clients ont aussi comparé
Même rayon, même caisse — huit monnaies et un taux bloqué 30 minutes.



