SXDOOL
SXDOOL DR12 120 mm case fan RGB 38 cfm 1500 RPM 16 dBA hydraulic bearing
A 120 mm case fan delivering 38 cfm airflow at 1500 RPM with 16 dBA noise using a hydraulic bearing rated for 20000 hours
- Quiet cooling at 16 dBA sound level
- Strong airflow of 38 cfm for heat removal
- Hydraulic bearing rated for 20000 hours life
- RGB LED lighting with 5V addressable control
- 120 mm frame fits standard case mounts
Single 120 mm RGB fan for quiet airflow
The SXDOOL DR12 is a 120 mm case fan built for builders who want coloured lighting without loud operation. It runs at 1500 RPM and pushes 38 cfm while producing only 16 dBA. A hydraulic bearing rated for 20000 hours keeps friction low over long use. The package includes one fan and four mounting screws.
38 cfm airflow with 16 dBA noise ceiling
At full speed the fan moves 38 cfm, which is enough for moderate component cooling or case circulation. The 16 dBA sound level means it stays near-silent in typical builds. Headroom ends when a high-heat CPU or GPU demands significantly more static pressure or volume than this single fan can supply. Power draw is 1.92 W at 12 V for the motor and 5 V for the LED.
Replaces basic fixed-speed
This unit upgrades from stock fans that run at constant speed, use sleeve bearings, or lack RGB control. The jump is worth it when you need adjustable colour lighting, quieter acoustics, and a longer bearing life in the same 120 mm slot. It does not suit builders who need higher static pressure for dense radiators or dual-fan push-pull configurations.
נקודות עיקריות
- Quiet cooling at 16 dBA sound level
- Strong airflow of 38 cfm for heat removal
- Hydraulic bearing rated for 20000 hours life
- RGB LED lighting with 5V addressable control
- 120 mm frame fits standard case mounts
מפרט טכני
טרם פורסם מפרט טכני לפריט זה.
שאלות על הפריט הזה
Will the 12 V fan header on my older motherboard power the 1500 RPM fan and 5 V RGB header drive the LED?
Yes, the fan runs on a 12 V four-pin header at 1500 RPM while the RGB LEDs draw power from a separate 5 V four-pin header, both using the included six-pin adapter.
How can I confirm the fan is spinning at the rated 1500 RPM and staying near 16 dBA after installation?
Check the RPM reading in BIOS or fan-control software — it should show roughly 1500 RPM — and listen for a quiet 16 dBA hum; the hydraulic bearing is rated for 20000 hours of operation.
Does the single-fan pack include mounting screws and the six-pin to dual-header adapter, or must I buy them separately?
The box contains one 120 mm RGB fan, four mounting screws and the six-pin connector that splits to a four-pin fan header and a four-pin 5 V RGB header; nothing else is required.
גם במדף הזה
לקוחות השוו בין אלה
אותו מדף, אותה קופה — שמונה מטבעות קריפטו ונעילת שער ל-30 דקות.
Black Box Corporation DisplayPort to DVI Fibre Optic Cable 15 ft 4.5 m 1.35 GB/s
- Consumer Electronics



