OWC 16GB DDR3 1333 PC3-10600 CL9 2Rx4 240-pin 1.5V ECC Registered RDIMM
- 16GB
- 240-Pin DDR3 ECC RD…
Prihvaćamo kriptovalute — tako kriptovalute koje posjedujete mogu kupiti pravi hardver.Plaćajte kriptovalutom, trošite je na pravi hardver. Besplatna osigurana dostava diljem svijeta iznad 399 $. Obični vanjski kartoni bez oznaka, otpremaju se iz Njemačke.Besplatna osigurana dostava iznad 399 $. Vaš je tečaj blokiran 30 minuta od otvaranja blagajne.Tečaj blokiran 30 minuta. Svaki je artikl zapečaćen, njegov serijski broj provjeren, i pokriven jamstvom od 24 mjeseca.Zapečaćen, jamstvo 24 mjeseca.
OWC
Adds 16 GB of DDR3 ECC registered memory at 1333 MHz for Dell PowerEdge R920, T410, T610 and T710 servers
Capacity 16GB
This 16GB DDR3 ECC registered DIMM is built for Dell PowerEdge R920, T410, T610 and T710 servers. It runs at 1333MHz with CL9 latency and 1.5V operation. The module uses a 2Rx4 rank configuration on a 240-pin interface. It is not compatible with standard desktop computers or unbuffered memory.
The module operates at the standard 1.5V DDR3 voltage without a heat spreader. Registered buffering reduces electrical load on the memory controller during sustained workloads. ECC circuitry adds minimal overhead while correcting single-bit errors. Power draw stays within JEDEC limits for PC3-10600 modules.
The bare green PCB fits directly into 240-pin DDR3 slots on the listed PowerEdge models. Registered signalling requires a compatible server chipset to function. Mixing with unbuffered DIMMs will prevent boot. The single-module design allows incremental capacity increases up to the system maximum.
| Brand | OWC |
|---|---|
| Part Number | 1R3D32R416GB |
| Capacity | 16GB |
| Type | 240-Pin DDR3 ECC RDIMM |
| Speed | DDR3 1333 (PC3 10600) |
| CAS Latency | CL9 |
| Voltage | 1.5V |
| ECC | Yes |
| Buffered/Registered | Registered |
| Rank | 2Rx4 |
| Heat Spreader | No |
| Compatible System | Dell PowerEdge R920 Dell PowerEdge T410 Dell PowerEdge T610 Dell PowerEdge T710 |
Druge verzije ovog modela
Ista obitelj, različita memorija, hladnjak ili frekvencija — usporedite prije kupnje.
Power off the server, open the chassis, align the notch on the 240-pin module with the slot key, press firmly until both latches click, then verify in BIOS that the 16GB module is recognised at 1333MHz. The step often missed is confirming the memory mode supports registered DIMMs and not mixing with unbuffered modules.
No scheduled maintenance is required for the module itself. Keep server air filters clean so the 1.5V DIMM stays within thermal limits. Replacement is only needed if a memory error persists after reseating, or when total capacity must exceed the slot limit of the R920, T410, T610 or T710 platform.
The memory controller’s maximum supported frequency of 1333MHz (PC3-10600) is the first ceiling; the module will not run faster. Beyond that, the 2Rx4 organisation and registered buffer add slight latency, so sustained bandwidth is capped by the DDR3 1333 interface rather than the 16GB capacity or 1.5V supply.
Također u ovoj kategoriji
Ista polica, ista blagajna — osam valuta i blokada tečaja na 30 minuta.
Ono što šaljete, i ono u čemu gledate cijene.
Poslano iz Vašeg novčanika na blagajni
Samo prikaz — katalog je izražen u dolarima
Nijedna valuta ne odgovara.
Odaberite jezik na kojem Vam se stranica obraća.
Nema odgovarajućeg jezika.
Novi ste ovdje?
Već imate račun?
Ne postoji automatsko resetiranje: ova trgovina ne šalje e-poštu, stoga ne postoji jednokratna poveznica koju biste mogli zatražiti. Ostavite adresu uz svoj račun, netko će je ručno obraditi.
Zahtjev zaprimljen
Ništa neće stići u Vaš pretinac e-pošte — ova trgovina uopće ne šalje e-poštu. Netko će to ručno preuzeti.
Sjetili ste se?