OWC 16GB DDR3 1333 PC3-10600 CL9 2Rx4 240-pin 1.5V ECC Registered RDIMM
- 16GB
- 240-Pin DDR3 ECC RD…
Aceitamos criptomoeda — para que as moedas que detém possam comprar material informático real.Pague em cripto, gaste-a em material informático real. Envio seguro gratuito para todo o mundo acima de 399 $. Caixas neutras, sem marca, expedidas a partir da Alemanha.Envio seguro gratuito acima de 399 $. A sua taxa fica bloqueada durante 30 minutos assim que abre a finalização da compra.Taxa bloqueada 30 minutos. Cada artigo é selado, o seu número de série é verificado, e está coberto por uma garantia de 24 meses.Selado, garantido 24 meses.
OWC
Adds 16 GB of DDR3 ECC registered memory at 1333 MHz for Dell PowerEdge R920, T410, T610 and T710 servers
Capacity 16GB
This 16GB DDR3 ECC registered DIMM is built for Dell PowerEdge R920, T410, T610 and T710 servers. It runs at 1333MHz with CL9 latency and 1.5V operation. The module uses a 2Rx4 rank configuration on a 240-pin interface. It is not compatible with standard desktop computers or unbuffered memory.
The module operates at the standard 1.5V DDR3 voltage without a heat spreader. Registered buffering reduces electrical load on the memory controller during sustained workloads. ECC circuitry adds minimal overhead while correcting single-bit errors. Power draw stays within JEDEC limits for PC3-10600 modules.
The bare green PCB fits directly into 240-pin DDR3 slots on the listed PowerEdge models. Registered signalling requires a compatible server chipset to function. Mixing with unbuffered DIMMs will prevent boot. The single-module design allows incremental capacity increases up to the system maximum.
| Brand | OWC |
|---|---|
| Part Number | 1R3D32R416GB |
| Capacity | 16GB |
| Type | 240-Pin DDR3 ECC RDIMM |
| Speed | DDR3 1333 (PC3 10600) |
| CAS Latency | CL9 |
| Voltage | 1.5V |
| ECC | Yes |
| Buffered/Registered | Registered |
| Rank | 2Rx4 |
| Heat Spreader | No |
| Compatible System | Dell PowerEdge R920 Dell PowerEdge T410 Dell PowerEdge T610 Dell PowerEdge T710 |
Outras versões deste modelo
Mesma família, memória, ventoinha ou frequência diferentes — compare antes de decidir.
Power off the server, open the chassis, align the notch on the 240-pin module with the slot key, press firmly until both latches click, then verify in BIOS that the 16GB module is recognised at 1333MHz. The step often missed is confirming the memory mode supports registered DIMMs and not mixing with unbuffered modules.
No scheduled maintenance is required for the module itself. Keep server air filters clean so the 1.5V DIMM stays within thermal limits. Replacement is only needed if a memory error persists after reseating, or when total capacity must exceed the slot limit of the R920, T410, T610 or T710 platform.
The memory controller’s maximum supported frequency of 1333MHz (PC3-10600) is the first ceiling; the module will not run faster. Beyond that, the 2Rx4 organisation and registered buffer add slight latency, so sustained bandwidth is capped by the DDR3 1333 interface rather than the 16GB capacity or 1.5V supply.
Também nesta secção
Mesma prateleira, mesma finalização da compra — oito moedas e uma taxa bloqueada durante 30 minutos.
O que paga, e a moeda em que vê os preços.
Enviado da sua carteira ao finalizar a compra
Apenas informativo — o catálogo está em dólares
Nenhuma moeda corresponde.
Escolha o idioma em que o site lhe fala.
Nenhum idioma corresponde.
Ainda não tem conta?
Já tem conta?
Não existe reposição automática: esta loja não envia qualquer e-mail, pelo que não há nenhum link de utilização única para pedir. Deixe o endereço na conta e ele será tratado manualmente.
Pedido registado
Não vai chegar nada à sua caixa de entrada — esta loja não envia qualquer e-mail. Alguém trata disto manualmente.
Recordou-se dela?