OWC 16GB DDR3 1333 PC3-10600 CL9 2Rx4 240-pin 1.5V ECC Registered RDIMM
- 16GB
- 240-Pin DDR3 ECC RD…
Vi tar emot kryptovaluta — så att kryptot du äger kan köpa riktig hårdvara.Betala med krypto, använd det till riktig hårdvara. Fri, försäkrad frakt över hela världen vid köp över 399 $. Neutrala, omärkta ytterkartonger, skickade från Tyskland.Fri, försäkrad frakt över 399 $. Din kurs låses i 30 minuter så snart kassan öppnas.Kursen låst i 30 minuter. Varje artikel är förseglad, har kontrollerat serienummer och täcks av 24 månaders garanti.Förseglad, 24 månaders garanti.
OWC
Adds 16 GB of DDR3 ECC registered memory at 1333 MHz for Dell PowerEdge R920, T410, T610 and T710 servers
Capacity 16GB
This 16GB DDR3 ECC registered DIMM is built for Dell PowerEdge R920, T410, T610 and T710 servers. It runs at 1333MHz with CL9 latency and 1.5V operation. The module uses a 2Rx4 rank configuration on a 240-pin interface. It is not compatible with standard desktop computers or unbuffered memory.
The module operates at the standard 1.5V DDR3 voltage without a heat spreader. Registered buffering reduces electrical load on the memory controller during sustained workloads. ECC circuitry adds minimal overhead while correcting single-bit errors. Power draw stays within JEDEC limits for PC3-10600 modules.
The bare green PCB fits directly into 240-pin DDR3 slots on the listed PowerEdge models. Registered signalling requires a compatible server chipset to function. Mixing with unbuffered DIMMs will prevent boot. The single-module design allows incremental capacity increases up to the system maximum.
| Brand | OWC |
|---|---|
| Part Number | 1R3D32R416GB |
| Capacity | 16GB |
| Type | 240-Pin DDR3 ECC RDIMM |
| Speed | DDR3 1333 (PC3 10600) |
| CAS Latency | CL9 |
| Voltage | 1.5V |
| ECC | Yes |
| Buffered/Registered | Registered |
| Rank | 2Rx4 |
| Heat Spreader | No |
| Compatible System | Dell PowerEdge R920 Dell PowerEdge T410 Dell PowerEdge T610 Dell PowerEdge T710 |
Andra versioner av den här modellen
Samma familj, men olika minne, kylning eller klockfrekvens — jämför innan du bestämmer dig.
Power off the server, open the chassis, align the notch on the 240-pin module with the slot key, press firmly until both latches click, then verify in BIOS that the 16GB module is recognised at 1333MHz. The step often missed is confirming the memory mode supports registered DIMMs and not mixing with unbuffered modules.
No scheduled maintenance is required for the module itself. Keep server air filters clean so the 1.5V DIMM stays within thermal limits. Replacement is only needed if a memory error persists after reseating, or when total capacity must exceed the slot limit of the R920, T410, T610 or T710 platform.
The memory controller’s maximum supported frequency of 1333MHz (PC3-10600) is the first ceiling; the module will not run faster. Beyond that, the 2Rx4 organisation and registered buffer add slight latency, so sustained bandwidth is capped by the DDR3 1333 interface rather than the 16GB capacity or 1.5V supply.
Även i den här avdelningen
Samma hylla, samma kassa — åtta mynt och ett 30-minuters kurslås.
Det du betalar med, och det du ser priserna i.
Skickas från din plånbok i kassan
Endast visning — katalogen är prissatt i US-dollar
Ingen valuta matchar.
Välj det språk du vill att webbplatsen ska visas på.
Inga språk matchar.
Ny här?
Har du redan ett konto?
Det finns ingen automatisk återställning: den här butiken skickar inga e-postmeddelanden, så det finns ingen engångslänk att begära. Lämna adressen kopplad till kontot, så hanteras den för hand.
Förfrågan noterad
Inget är på väg till din inkorg — den här butiken skickar aldrig e-post. Någon tar hand om detta manuellt.
Kom du på det?