OWC 16GB DDR3 1333 PC3-10600 CL9 2Rx4 240-pin 1.5V ECC Registered RDIMM
- 16GB
- 240-Pin DDR3 ECC RD…
Accettiamo criptovalute — così le crypto che Lei possiede possono comprare hardware reale.Paghi in crypto, la spenda in hardware reale. Spedizione assicurata gratuita in tutto il mondo oltre i 399 $. Cartoni neutri, senza marchio, spediti dalla Germania.Spedizione assicurata gratuita oltre i 399 $. Il Suo tasso resta bloccato per 30 minuti dall’apertura del checkout.Tasso bloccato 30 minuti. Ogni articolo è sigillato, il numero di serie è verificato, ed è coperto da una garanzia di 24 mesi.Sigillato, garantito 24 mesi.
OWC
Adds 16 GB of DDR3 ECC registered memory at 1333 MHz for Dell PowerEdge R920, T410, T610 and T710 servers
Capacity 16GB
This 16GB DDR3 ECC registered DIMM is built for Dell PowerEdge R920, T410, T610 and T710 servers. It runs at 1333MHz with CL9 latency and 1.5V operation. The module uses a 2Rx4 rank configuration on a 240-pin interface. It is not compatible with standard desktop computers or unbuffered memory.
The module operates at the standard 1.5V DDR3 voltage without a heat spreader. Registered buffering reduces electrical load on the memory controller during sustained workloads. ECC circuitry adds minimal overhead while correcting single-bit errors. Power draw stays within JEDEC limits for PC3-10600 modules.
The bare green PCB fits directly into 240-pin DDR3 slots on the listed PowerEdge models. Registered signalling requires a compatible server chipset to function. Mixing with unbuffered DIMMs will prevent boot. The single-module design allows incremental capacity increases up to the system maximum.
| Brand | OWC |
|---|---|
| Part Number | 1R3D32R416GB |
| Capacity | 16GB |
| Type | 240-Pin DDR3 ECC RDIMM |
| Speed | DDR3 1333 (PC3 10600) |
| CAS Latency | CL9 |
| Voltage | 1.5V |
| ECC | Yes |
| Buffered/Registered | Registered |
| Rank | 2Rx4 |
| Heat Spreader | No |
| Compatible System | Dell PowerEdge R920 Dell PowerEdge T410 Dell PowerEdge T610 Dell PowerEdge T710 |
Altre versioni di questo modello
Stessa famiglia, con memoria, dissipatore o frequenza diversi — confronti prima di decidere.
Power off the server, open the chassis, align the notch on the 240-pin module with the slot key, press firmly until both latches click, then verify in BIOS that the 16GB module is recognised at 1333MHz. The step often missed is confirming the memory mode supports registered DIMMs and not mixing with unbuffered modules.
No scheduled maintenance is required for the module itself. Keep server air filters clean so the 1.5V DIMM stays within thermal limits. Replacement is only needed if a memory error persists after reseating, or when total capacity must exceed the slot limit of the R920, T410, T610 or T710 platform.
The memory controller’s maximum supported frequency of 1333MHz (PC3-10600) is the first ceiling; the module will not run faster. Beyond that, the 2Rx4 organisation and registered buffer add slight latency, so sustained bandwidth is capped by the DDR3 1333 interface rather than the 16GB capacity or 1.5V supply.
Anche in questo reparto
Stesso reparto, stessa cassa — otto monete e un cambio bloccato per 30 minuti.
Cosa invia per pagare, e in quale valuta legge i prezzi.
Inviato dal Suo portafoglio alla cassa
Solo a titolo indicativo — il catalogo è espresso in dollari
Nessuna valuta corrisponde.
Scelga la lingua in cui il sito Le parla.
Nessuna lingua corrisponde.
Prima visita?
Ne ha già uno?
Non esiste un ripristino automatico: questo negozio non invia e-mail, quindi non esiste alcun link monouso da richiedere. Lasci l’indirizzo sull’account: verrà gestito manualmente.
Richiesta registrata
Non arriverà nulla nella Sua casella di posta — questo negozio non invia e-mail. Qualcuno se ne occupa manualmente.
L’ha ritrovata?