Accettiamo criptovalute — così le crypto che Lei possiede possono comprare hardware reale.Paghi in crypto, la spenda in hardware reale. Spedizione assicurata gratuita in tutto il mondo oltre i 399 $. Cartoni neutri, senza marchio, spediti dalla Germania.Spedizione assicurata gratuita oltre i 399 $. Il Suo tasso resta bloccato per 30 minuti dall’apertura del checkout.Tasso bloccato 30 minuti. Ogni articolo è sigillato, il numero di serie è verificato, ed è coperto da una garanzia di 24 mesi.Sigillato, garantito 24 mesi.

Articoli preferiti Accedi

NEMIX RAM

NEMIX RAM 32GB DDR5 5200 PC5-41600 CL42 2Rx8 ECC UDIMM 1.1V

SKU CH-WYJE-HWHA9

32 GB DDR5-5200 ECC UDIMM with CL42 latency, 2Rx8 organisation and 1.1 V operation for server workloads

  • Capacity32GB
  • Type288-Pin DDR5 ECC UDIMM
  • SpeedDDR5 5200 (PC5 41600)
  • CAS LatencyCL42
  • Voltage1.10V
  • ECCYes
  • 32 GB capacity expands server memory headroom
  • DDR5 5200 speed delivers high data throughput
  • ECC protection corrects single-bit errors automatically
  • 10 V operation reduces power draw per module
  • 2Rx8 dual-rank layout increases memory density

32 GB DDR5 ECC UDIMM for servers and workstations

This single 32 GB DDR5 5200 module delivers error-correcting code memory for platforms that require data integrity. It targets IT professionals upgrading enterprise servers, workstations or NAS devices where ECC unbuffered DIMMs are specified. The 2Rx8 organisation suits high-capacity configurations on compatible motherboards.

Unbuffered 288-pin design with no heat spreader

The bare green PCB fits standard 288-pin DDR5 slots without extra height clearance concerns. Unbuffered signalling keeps latency low for supported consumer and entry-level server chipsets. Major OEM DRAM from Samsung, Micron or Hynix is used depending on supply, and every module is stress-tested under load before shipment.

CL42 latency at 1.1 V defines the performance

Rated at DDR5 5200 (PC5-41600) with CAS latency 42, this module runs at the baseline JEDEC voltage of 1.1 V. Builders needing tighter timings, higher frequencies or registered DIMMs must select a different part.

Punti di forza

  • 32 GB capacity expands server memory headroom
  • DDR5 5200 speed delivers high data throughput
  • ECC protection corrects single-bit errors automatically
  • 10 V operation reduces power draw per module
  • 2Rx8 dual-rank layout increases memory density

Caratteristiche tecniche

BrandNEMIX RAM
SeriesNEMIX RAM Original Series Memory
ModelDDR5 ECC Unbuffered UDIMM Memory
Part NumberME41600-328K1
Capacity32GB
Type288-Pin DDR5 ECC UDIMM
SpeedDDR5 5200 (PC5 41600)
CAS LatencyCL42
Voltage1.10V
ECCYes
Buffered/RegisteredUnbuffered
Rank2Rx8
ChipsetMajor OEM Samsung, Micron, Hynix
Heat SpreaderNo
FeaturesDDR5 ECC Unbuffered UDIMM Motherboard Compatible

Altre versioni di questo modello

altri 5 nella stessa gamma

Stessa famiglia, con memoria, dissipatore o frequenza diversi — confronti prima di decidere.

Domande su questo articolo

What DDR5 speed and PC5 rating does this 32GB module run at?

It operates at DDR5 5200 with a PC5-41600 data rate, so the memory controller will cap transfers at that 5200 MT/s ceiling unless the platform forces a lower JEDEC bin.

What physical slot and pin count does the 288-pin UDIMM require?

The stick uses a standard 288-pin DDR5 UDIMM edge connector and fits any desktop or workstation board with an unbuffered DDR5 DIMM slot; no heat spreader means low-profile coolers clear it easily.

How is the ECC UDIMM installed and what step do builders often miss?

Power down, open the retention clips, align the off-centre key notch with the slot, press firmly until both clips snap shut, then enable ECC in the BIOS — skipping that BIOS toggle leaves error correction inactive.

Anche in questo reparto

Anche i clienti hanno confrontato questi

Stesso reparto, stessa cassa — otto monete e un cambio bloccato per 30 minuti.