We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Green bare DDR5 ECC UDIMM module 32GB 288-pin

NEMIX RAM

NEMIX RAM 32GB DDR5 5200 PC5-41600 CL42 2Rx8 ECC UDIMM 1.1V

SKU CH-WYJE-HWHA9

32 GB DDR5-5200 ECC UDIMM with CL42 latency, 2Rx8 organisation and 1.1 V operation for server workloads

  • Capacity32GB
  • Type288-Pin DDR5 ECC UDIMM
  • SpeedDDR5 5200 (PC5 41600)
  • CAS LatencyCL42
  • Voltage1.10V
  • ECCYes

Capacity 32GB

  • 32 GB capacity expands server memory headroom
  • DDR5 5200 speed delivers high data throughput
  • ECC protection corrects single-bit errors automatically
  • 10 V operation reduces power draw per module
  • 2Rx8 dual-rank layout increases memory density

32 GB DDR5 ECC UDIMM for servers and workstations

This single 32 GB DDR5 5200 module delivers error-correcting code memory for platforms that require data integrity. It targets IT professionals upgrading enterprise servers, workstations or NAS devices where ECC unbuffered DIMMs are specified. The 2Rx8 organisation suits high-capacity configurations on compatible motherboards.

Unbuffered 288-pin design with no heat spreader

The bare green PCB fits standard 288-pin DDR5 slots without extra height clearance concerns. Unbuffered signalling keeps latency low for supported consumer and entry-level server chipsets. Major OEM DRAM from Samsung, Micron or Hynix is used depending on supply, and every module is stress-tested under load before shipment.

CL42 latency at 1.1 V defines the performance

Rated at DDR5 5200 (PC5-41600) with CAS latency 42, this module runs at the baseline JEDEC voltage of 1.1 V. Builders needing tighter timings, higher frequencies or registered DIMMs must select a different part.

Highlights

  • 32 GB capacity expands server memory headroom
  • DDR5 5200 speed delivers high data throughput
  • ECC protection corrects single-bit errors automatically
  • 10 V operation reduces power draw per module
  • 2Rx8 dual-rank layout increases memory density

Specifications

BrandNEMIX RAM
SeriesNEMIX RAM Original Series Memory
ModelDDR5 ECC Unbuffered UDIMM Memory
Part NumberME41600-328K1
Capacity32GB
Type288-Pin DDR5 ECC UDIMM
SpeedDDR5 5200 (PC5 41600)
CAS LatencyCL42
Voltage1.10V
ECCYes
Buffered/RegisteredUnbuffered
Rank2Rx8
ChipsetMajor OEM Samsung, Micron, Hynix
Heat SpreaderNo
FeaturesDDR5 ECC Unbuffered UDIMM Motherboard Compatible

Other versions of this model

5 more in the same range

Same family, different memory, cooler or clock — compare before you commit.

Questions about this item

What DDR5 speed and PC5 rating does this 32GB module run at?

It operates at DDR5 5200 with a PC5-41600 data rate, so the memory controller will cap transfers at that 5200 MT/s ceiling unless the platform forces a lower JEDEC bin.

What physical slot and pin count does the 288-pin UDIMM require?

The stick uses a standard 288-pin DDR5 UDIMM edge connector and fits any desktop or workstation board with an unbuffered DDR5 DIMM slot; no heat spreader means low-profile coolers clear it easily.

How is the ECC UDIMM installed and what step do builders often miss?

Power down, open the retention clips, align the off-centre key notch with the slot, press firmly until both clips snap shut, then enable ECC in the BIOS — skipping that BIOS toggle leaves error correction inactive.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.