暗号資産でのお支払いに対応—お手持ちのコインで、本物のハードウェアをご購入いただけます。暗号資産で支払い、本物のハードウェアに使う。 $399以上のご注文で、世界中どこでも送料無料（保険付き）。無地・ノーブランドの外箱で、ドイツから発送いたします。$399以上で送料無料（保険付き）。 注文手続きを開始すると、レートは30分間ロックされます。レートは30分間ロック。 すべての商品は未開封で、シリアル番号を確認した上で、24か月保証が付いています。未開封、24か月保証。

ウォッチリスト ログイン
Silver 2.5 inch SAS enterprise SSD with Dell label

DELL

DELL PX05SMB080Y 800GB SAS 2.5 enterprise SSD CN3JH-CO3-OSTK

SKU CH-D3C0-ZMK4M MPN PX05SMB080Y

An 800 GB SAS enterprise SSD in a 2.5 inch form factor, built for write-intensive workloads in Dell PowerEdge servers

  • 800 GB capacity for large enterprise datasets
  • 12 Gbps SAS interface for high-throughput server workloads
  • 5 inch SFF form factor fits dense PowerEdge bays
  • MLC write-intensive endurance for sustained database performance
  • Hot-swap design enables drive replacement without downtime

Dell 800GB SAS Enterprise SSD

This Dell PX05SMB080Y is an 800GB enterprise solid-state drive with a 12Gbps SAS interface in a 2.5 inch form factor. It uses MLC flash and supports hot-swap installation in compatible Dell PowerEdge servers.

Replaces slower SAS HDDs or smaller SSDs

The jump is worth it when your workload demands consistent write endurance and low latency on a 12Gbps SAS backplane. It is not for desktop PCs, consumer laptops or any system lacking a SAS controller and 2.5 inch hot-swap bays.

Verify SAS controller and tray compatibility

Confirm your server has a 12Gbps SAS HBA or RAID card and an available 2.5 inch hot-swap bay with the correct Dell drive tray. The drive ships without a tray sticker, so ensure the tray matches your chassis before ordering.

特長

  • 800 GB capacity for large enterprise datasets
  • 12 Gbps SAS interface for high-throughput server workloads
  • 5 inch SFF form factor fits dense PowerEdge bays
  • MLC write-intensive endurance for sustained database performance
  • Hot-swap design enables drive replacement without downtime

仕様

この商品の仕様はまだ公開されていません。

この商品に関する質問

What drive bay size does the 2.5 SFF form factor require?

The drive fits a standard 2.5-inch small form factor bay in compatible Dell PowerEdge servers.

How is the hot-swap tray secured during installation?

Slide the SSD into the server-specific tray until the SAS connector seats fully, then lock the tray latch to engage the backplane.

When should the MLC NAND be monitored for replacement?

Monitor SMART wear indicators; replace the drive when the media wear-out metric approaches the rated endurance limit for 800GB write-intensive workloads.

同じ売り場の商品

よく比較されている商品

同じ売り場、同じレジ — 8種類のコインと30分間のレートロック。