EN-Labs 11-001-366 PCIe x4 USB 3.2 10Gbps 5-port card
- no
- 12CM Case fan,screw…
Hynix
A 4 GB registered ECC DDR4 module running at 2400 MHz for error-correcting desktop workloads
This 4 GB DDR4 registered ECC module runs at 2400 MHz with a PC4-19200 rating. It uses a single-rank 1Rx8 organisation and includes an on-board register for signal integrity. The stick is intended for desktop platforms that specifically require registered ECC memory.
The register and ECC logic alter the electrical load on the memory bus, so the module will only function on motherboards that explicitly support registered ECC DIMMs. Standard consumer desktop boards without that support will not post with this memory installed. No extra software or cables are bundled with the stick.
Installation is a normal DIMM insertion, but the system must recognise registered ECC at POST or the module will appear as unusable. Builders who need unbuffered non-ECC memory or higher capacities per slot cannot use this part. Verify the motherboard manual for registered ECC qualification before purchase.
この商品の仕様はまだ公開されていません。
The registered ECC circuitry is built into the module and operates without firmware updates or replaceable parts for the life of the product.
The JEDEC-rated 2400 MHz data rate and PC4-19200 bandwidth ceiling are the primary limits under sustained load.
Standard DDR4 1Rx8 registered ECC modules run at low voltage and generate minimal heat, requiring only normal case airflow.
同じ売り場の商品
同じ売り場、同じレジ — 8種類のコインと30分間のレートロック。
お支払いに使うコインと、価格表示に使う通貨です。
チェックアウト時にウォレットから送信されます。
表示のみ—カタログの価格は米ドル建てです。
該当する通貨がありません。
サイトの表示言語を選択してください。
No language matches that.
初めてのご利用ですか?
すでにお持ちですか?
自動的な再設定はありません。当店はメールを送信しないため、ワンタイムリンクをお送りすることもできません。アカウントにメールアドレスを残しておいていただければ、担当者が手作業で確認いたします。
リクエストを受け付けました
受信箱に何かが届くことはありません — 当店はメールを一切送信していません。担当者が手作業で確認いたします。
思い出しましたか?