暗号資産でのお支払いに対応—お手持ちのコインで、本物のハードウェアをご購入いただけます。暗号資産で支払い、本物のハードウェアに使う。 $399以上のご注文で、世界中どこでも送料無料（保険付き）。無地・ノーブランドの外箱で、ドイツから発送いたします。$399以上で送料無料（保険付き）。 注文手続きを開始すると、レートは30分間ロックされます。レートは30分間ロック。 すべての商品は未開封で、シリアル番号を確認した上で、24か月保証が付いています。未開封、24か月保証。

ウォッチリスト ログイン
Two green DDR5 RDIMM modules without heat spreaders, 192GB total

NEMIX RAM

NEMIX RAM 192GB (2x96GB) DDR5 5600 CL46 ECC Registered RDIMM for Supermicro H13SST-G memory upgrade

SKU CH-DYHW-J4X4X

A 192GB DDR5 5600 CL46 ECC registered RDIMM kit (2×96GB, 1.1V, 2Rx4) validated for the Supermicro H13SST-G motherboard

  • Capacity192GB (2 x 96GB)
  • Type288-Pin DDR5 RDIMM
  • SpeedDDR5 5600 (PC5 44800)
  • CAS LatencyCL46
  • Voltage1.10V
  • ECCYes

Size 192GB 2X96GB

他に 24点の構成を表示
  • 192 GB capacity in a matched 2 × 96 GB kit
  • DDR5-5600 (PC5-44800) speed with CL46 latency
  • Registered ECC RDIMM for error correction and signal integrity
  • 1 V operation at 2Rx4 rank configuration
  • Verified compatibility with Supermicro H13SST-G motherboard

192GB DDR5-5600 ECC RDIMM kit

This 192GB kit contains two 96GB DDR5-5600 registered ECC RDIMMs built for the Supermicro H13SST-G motherboard. It targets administrators who need maximum registered capacity per slot in a validated configuration. The modules run at 1.1V with CL46 latency and a 2Rx4 organisation. Buyers who need unbuffered UDIMMs or laptop SODIMMs cannot use this product.

Registered ECC headroom at 5600 MT/s

The registered architecture buffers address and command signals so both DIMM slots can be populated at the full 192GB without reducing the 5600 MT/s data rate. ECC corrects single-bit errors on the fly to prevent silent data corruption. The kit reaches its limit when the platform's maximum supported capacity per slot or total memory ceiling is lower than 192GB.

288-pin RDIMM fit for Supermicro H13SST-G

Each module uses the 288-pin RDIMM form factor required by the H13SST-G and draws 1.1V, matching the board's native DDR5 voltage rail. No heat spreader is fitted, leaving clearance for dense server chassis airflow. The kit frees the installer from mixing ranks or speeds; it simply occupies the approved slots in the order the motherboard manual specifies.

特長

  • 192 GB capacity in a matched 2 × 96 GB kit
  • DDR5-5600 (PC5-44800) speed with CL46 latency
  • Registered ECC RDIMM for error correction and signal integrity
  • 1 V operation at 2Rx4 rank configuration
  • Verified compatibility with Supermicro H13SST-G motherboard

仕様

BrandNEMIX RAM
SeriesNEMIX RAM Original Series Server Memory
ModelDDR5 ECC RDIMM Registered Server Memory
Part NumberMR44800-9624K2
Capacity192GB (2 x 96GB)
Type288-Pin DDR5 RDIMM
SpeedDDR5 5600 (PC5 44800)
CAS LatencyCL46
Voltage1.10V
ECCYes
Buffered/RegisteredRegistered
Rank2Rx4
ChipsetMajor OEM Samsung, Micron, Hynix
Heat SpreaderNo
Compatible SystemSupermicro
FeaturesDDR5 ECC RDIMM Motherboard Compatible
Package Content192GB 2X96GB DDR5 5600MHz PC5-44800 2Rx4 1.1V 288-PIN ECC RDIMM KIT

このモデルの他のバージョン

同シリーズにさらに 5点

同じファミリーで、メモリ・クーラー・クロックが異なります — 購入前に比較してください。

この商品に関する質問

Will the 2Rx4 registered DDR5 5600 modules work with the Supermicro H13SST-G memory controller alongside any existing RDIMMs?

The kit is spec-matched to the H13SST-G memory population rules. Install modules in the order the motherboard manual specifies for the total capacity you want.

How can I confirm the kit runs at DDR5 5600 with CL46 and ECC active after installation?

Enter the BIOS and verify the memory speed reads 5600 MT/s, CAS latency 46, voltage 1.10 V and that ECC is reported as enabled for each DIMM.

Does the 192 GB kit include only the two 96 GB RDIMMs or are heat spreaders or cables also supplied?

The package contains the two 96 GB DDR5 5600 CL46 288-pin ECC registered RDIMMs only; no heat spreaders or extra cables are included.

同じ売り場の商品

よく比較されている商品

同じ売り場、同じレジ — 8種類のコインと30分間のレートロック。