暗号資産でのお支払いに対応—お手持ちのコインで、本物のハードウェアをご購入いただけます。暗号資産で支払い、本物のハードウェアに使う。 $399以上のご注文で、世界中どこでも送料無料（保険付き）。無地・ノーブランドの外箱で、ドイツから発送いたします。$399以上で送料無料（保険付き）。 注文手続きを開始すると、レートは30分間ロックされます。レートは30分間ロック。 すべての商品は未開封で、シリアル番号を確認した上で、24か月保証が付いています。未開封、24か月保証。

ウォッチリスト ログイン
Two green 288-pin DDR5 RDIMM modules, no heat spreaders, 256GB kit

NEMIX RAM

NEMIX RAM DDR5 5600 256GB (2x128GB) ECC RDIMM CL46 1.1V 4Rx4 Supermicro X14SDW-64C-SP9F memory upgrade

SKU CH-T93Y-F93V4

256 GB DDR5 5600 registered ECC kit in two 128 GB 4Rx4 modules at 1.1 V CL46, validated for Supermicro X14SDW-64C-SP9F

  • Capacity256GB (2 x 128GB)
  • Type288-Pin DDR5 RDIMM
  • SpeedDDR5 5600 (PC5 44800)
  • CAS LatencyCL46
  • Voltage1.10V
  • ECCYes

Size 256GB 2X128GB

他に 4点の構成を表示
  • 256 GB total capacity from two 128 GB modules
  • DDR5 5600 speed with CL46 latency for rated throughput
  • Registered ECC architecture corrects single-bit errors on the fly
  • 1 V operation matches the server memory controller specification
  • Verified fit for Supermicro X14SDW-64C-SP9F motherboard

Exact-match server upgrade

This 256GB kit delivers two 128GB DDR5 5600 RDIMM modules built to the Supermicro X14SDW-64C-SP9F memory controller specification. Registered ECC architecture with 4Rx4 organisation and CL46 timing at 1.1V ensures the board recognises full capacity at rated speed without manual tuning.

256GB registered ECC headroom

Dual-rank 4Rx4 density lets the platform address the full 256GB across two slots while ECC corrects single-bit errors on the fly. Registered buffering offloads the controller so every populated slot runs at 5600 MT/s, though total capacity is capped at the two-module kit and the board's maximum supported population.

288-pin RDIMM form factor

Modules use the standard 288-pin Registered DIMM keying required by the target motherboard, not UDIMM or SODIMM layouts. No heat spreader is fitted, so airflow in dense server chassis passes directly over the DRAM packages for consistent thermal behaviour under sustained load.

特長

  • 256 GB total capacity from two 128 GB modules
  • DDR5 5600 speed with CL46 latency for rated throughput
  • Registered ECC architecture corrects single-bit errors on the fly
  • 1 V operation matches the server memory controller specification
  • Verified fit for Supermicro X14SDW-64C-SP9F motherboard

仕様

BrandNEMIX RAM
SeriesNEMIX RAM Original Series Server Memory
ModelDDR5 ECC RDIMM Registered Server Memory
Part NumberMR44800-744K2
Capacity256GB (2 x 128GB)
Type288-Pin DDR5 RDIMM
SpeedDDR5 5600 (PC5 44800)
CAS LatencyCL46
Voltage1.10V
ECCYes
Buffered/RegisteredRegistered
Rank4Rx4
ChipsetMajor OEM Samsung, Micron, Hynix
Heat SpreaderNo
Compatible SystemSupermicro
FeaturesDDR5 ECC RDIMM Motherboard Compatible
Package Content256GB 2X128GB DDR5 5600MHz PC5-44800 4Rx4 1.1V 288-PIN ECC RDIMM KIT

このモデルの他のバージョン

同シリーズにさらに 5点

同じファミリーで、メモリ・クーラー・クロックが異なります — 購入前に比較してください。

この商品に関する質問

Will these 4Rx4 DDR5-5600 RDIMMs run at full speed alongside older DDR5-4800 modules already in my Supermicro X14SDW-64C-SP9F?

The kit is spec-matched to the board's DDR5-5600 (PC5-44800) memory controller. Mixing with DDR5-4800 modules will force the system to run all slots at the lower 4800 MT/s speed and may violate the motherboard's population rules for registered ECC DIMMs.

How can I confirm the 256 GB kit is detected at DDR5-5600 CL46 with ECC active after installation?

Enter the BIOS/UEFI on the Supermicro X14SDW-64C-SP9F and verify the memory information screen shows 256 GB total, DDR5-5600 (PC5-44800) data rate, CL46 timings, 1.10 V voltage, and ECC enabled for each of the two 128 GB 4Rx4 RDIMMs.

What exactly ships in the box and do I need any extra brackets or cables for the Supermicro X14SDW-64C-SP9F?

The package contains only the two 128 GB 288-pin DDR5-5600 ECC Registered RDIMMs. No heat spreaders, brackets, cables or additional hardware are included; the modules install directly into the motherboard's DDR5 RDIMM slots.

同じ売り場の商品

よく比較されている商品

同じ売り場、同じレジ — 8種類のコインと30分間のレートロック。