OWC 16GB DDR5 5600 CL46 1Rx8 288-pin 1.1V UDIMM for Dell Inspiron 3030

Dell Inspiron 3030 memory upgrade

This 16GB DDR5 module is built specifically for the Dell Inspiron 3030 desktop. It delivers a direct capacity increase for owners of that system who need more headroom for everyday multitasking and larger workloads. The single-rank 1Rx8 layout keeps the electrical load light on the memory controller. Buyers using a different platform or requiring ECC error correction should look elsewhere.

Drop-in 288-pin UDIMM for the Inspiron 3030

The stick uses the standard 288-pin unbuffered DDR5 form factor and runs at the JEDEC 1.1V baseline, so it installs without BIOS voltage tweaks. It occupies one slot and leaves any second slot free for a matching module if the board supports dual-channel operation. No heat spreader is fitted, so clearance inside compact chassis remains generous. Systems that demand registered or load-reduced DIMMs cannot use this kit.

Steady throughput at CL46 5600

Rated at 5600 MT/s with a CL46 latency, the module maintains its specified timing during extended sessions rather than only in short bursts. JEDEC compliance and 100% factory testing mean the rated speed is sustained under continuous load without manual overclocking. Workstations and NAS units that run memory-intensive tasks for hours will see consistent bandwidth. Builds that need lower latency bins or higher frequency headroom will not find it here.