暗号資産でのお支払いに対応—お手持ちのコインで、本物のハードウェアをご購入いただけます。暗号資産で支払い、本物のハードウェアに使う。 $399以上のご注文で、世界中どこでも送料無料（保険付き）。無地・ノーブランドの外箱で、ドイツから発送いたします。$399以上で送料無料（保険付き）。 注文手続きを開始すると、レートは30分間ロックされます。レートは30分間ロック。 すべての商品は未開封で、シリアル番号を確認した上で、24か月保証が付いています。未開封、24か月保証。

ウォッチリスト ログイン
Green circuit board with black memory chips and gold edge contacts

OWC

OWC 8GB DDR3L 1600 PC3L-12800 CL11 1Rx4 240-pin 1.35V ECC Registered RDIMM memory upgrade

SKU CH-3YKY-J6KSK

8GB DDR3L 1600 ECC registered RDIMM for Dell PowerEdge M610, M610X, M710 and M710HD servers

  • Capacity8GB
  • Type240-Pin DDR3L ECC RDIMM
  • SpeedDDR3L 1600 (PC3L 12800)
  • CAS LatencyCL11
  • Voltage1.35V
  • ECCYes

Capacity 8GB

  • ECC registered design prevents data corruption in critical workloads
  • DDR3L 1600MHz speed with CL11 latency boosts server responsiveness
  • Low 1.35V operation reduces power draw and heat
  • Single 8GB 1Rx4 module simplifies capacity scaling
  • Validated for Dell PowerEdge M610, M610X, M710, M710HD

Server memory upgrade

This 8GB DDR3L RDIMM is built for Dell PowerEdge M610, M610X, M710 and M710HD servers. It delivers ECC registered operation at 1600MHz for workloads that require error correction and signal integrity. The module replaces Dell part numbers A7134886, A7545680, RKR5J and SNPRKR5JC/8G. It is not compatible with standard desktop computers.

Registered 240-pin form factor

The 240-pin DDR3L design fits server DIMM slots that accept registered modules. ECC registered buffering reduces electrical load on the memory controller, allowing higher capacities per channel. No heat spreader is fitted, so airflow in dense blade chassis remains unimpeded. This module cannot be mixed with unbuffered memory in the same system.

1.35V DDR3L at CL11

Operating at 1.35V, this PC3L-12800 module runs at CAS latency 11 with a 1Rx4 organisation. The lower voltage reduces power draw compared to standard DDR3 while maintaining 1600MHz throughput. Buyers needing higher density per slot or unbuffered ECC for workstation boards should look elsewhere.

特長

  • ECC registered design prevents data corruption in critical workloads
  • DDR3L 1600MHz speed with CL11 latency boosts server responsiveness
  • Low 1.35V operation reduces power draw and heat
  • Single 8GB 1Rx4 module simplifies capacity scaling
  • Validated for Dell PowerEdge M610, M610X, M710, M710HD

仕様

BrandOWC
Part Number1R6T31R408GB
Capacity8GB
Type240-Pin DDR3L ECC RDIMM
SpeedDDR3L 1600 (PC3L 12800)
CAS LatencyCL11
Voltage1.35V
ECCYes
Buffered/RegisteredRegistered
Rank1Rx4
Heat SpreaderNo
Compatible SystemDell PowerEdge M610
Dell PowerEdge M610X
Dell PowerEdge M710
Dell PowerEdge M710HD

このモデルの他のバージョン

同シリーズにさらに 5点

同じファミリーで、メモリ・クーラー・クロックが異なります — 購入前に比較してください。

この商品に関する質問

Does the PC3L-12800 DDR3L 1600 interface cap at 1600 MHz in these Dell PowerEdge servers?

Yes, the module runs at DDR3L 1600 (PC3L-12800) CL11, which is the rated speed for the M610, M610X, M710 and M710HD platforms.

Will the 240-pin 1.35 V registered DIMM fit the memory slots in a Dell PowerEdge M710HD blade?

The M710HD uses standard 240-pin DDR3L RDIMM slots, so this 1.35 V registered module seats directly without an adapter.

What is the correct way to install this 1Rx4 ECC registered DIMM, and which step do people often miss?

Power down the server, open the chassis, align the notch on the 240-pin module with the slot key, press firmly until both ejector clips lock, then verify in BIOS that ECC registered mode is enabled.

同じ売り場の商品

よく比較されている商品

同じ売り場、同じレジ — 8種類のコインと30分間のレートロック。