Timetec 8GB DDR3L 1866MHz CL13 1.35V 204-Pin SODIMM laptop RAM
- 8GB
- 204-Pin DDR3 SO-DIMM
Timetec
8GB DDR4 server memory running at 2400MHz with ECC error correction and CL17 latency
Capacity 8GB
This 8GB module uses 288-pin DDR4 SDRAM rated at 2400MHz with PC4-19200 bandwidth. It operates at 1.2V with a CAS latency of 17 and features ECC error correction in an unbuffered, single-rank 1Rx8 configuration built on Hynix ICs.
It is designed for qualified server platforms from vendors such as Dell, HP, Lenovo, Supermicro and Synology. Desktop or laptop systems cannot use this memory, and boards that require registered or load-reduced DIMMs are not supported.
The package contains only the single memory module. There are no cables, adapters, cooling components or software utilities included, so installation relies entirely on the host system's existing hardware and firmware.
| Capacity | 8GB |
|---|---|
| Type | 288-Pin DDR4 SDRAM |
| Speed | DDR4 2400 (PC4 19200) |
| CAS Latency | CL17 |
| Voltage | 1.20V |
| ECC | Yes |
| Buffered/Registered | Unbuffered |
| Rank | 1Rx8 |
このモデルの他のバージョン
同じファミリーで、メモリ・クーラー・クロックが異なります — 購入前に比較してください。
It fits a standard DDR4 UDIMM slot with 288 pins. The board must support unbuffered ECC memory at 1.2 V and accept single-rank 1Rx8 modules.
The system will run all modules at the speed and timings of the slowest stick. This module is rated for DDR4 2400 at CL17; older DDR4 will pull the bus down to its own lower rate.
Enter the BIOS or UEFI and verify that ECC is reported as enabled. You can also run a memory test utility that logs corrected errors; a clean pass with ECC shown active means the module is working as intended.
同じ売り場の商品
同じ売り場、同じレジ — 8種類のコインと30分間のレートロック。
お支払いに使うコインと、価格表示に使う通貨です。
チェックアウト時にウォレットから送信されます。
表示のみ—カタログの価格は米ドル建てです。
該当する通貨がありません。
サイトの表示言語を選択してください。
一致する言語がありません。
初めてのご利用ですか?
すでにお持ちですか?
自動的な再設定はありません。当店はメールを送信しないため、ワンタイムリンクをお送りすることもできません。アカウントにメールアドレスを残しておいていただければ、担当者が手作業で確認いたします。
リクエストを受け付けました
受信箱に何かが届くことはありません — 当店はメールを一切送信していません。担当者が手作業で確認いたします。
思い出しましたか?