DEWANG
DEWANG 3D Printing Pen Blue 1.75mm 65g
A lightweight 65 g pen draws three-dimensional shapes in mid-air using 1.75 mm ABS or PLA filament
- Type3D Printing Pen
- ColorBlue
- Number of Extruders1
- Body MaterialPlastic
- Filament Diameter1.75mm
- Max Working Speedadjustable
Color Blue
- Blue
- Yellow
- Purple
- Pink
취소선으로 표시된 버전은 존재하지만, 이곳에서는 취급하지 않습니다.
- Draw vertical or horizontal shapes in the air
- Compatible with ABS and PLA 1.75mm filaments
- Ultra-light 65g body reduces hand fatigue
- Ergonomic grip suits children, designers and hobbyists
- Encourages imagination and 3D art creation
Creative 3D Drawing Pen for All Ages
The DEWANG 3D Printing Pen in blue lets users draw solid shapes in the air using 1.75mm ABS or PLA filament. Its lightweight 65g plastic body and single extruder suit children, hobbyists and designers who want a simple tool for freehand 3D art. Adjustable working speed gives control over flow for different project needs.
Thermals and Power in Normal Use
The pen heats only the nozzle area required to melt filament during extrusion. Plastic housing stays cool enough for comfortable extended sessions without active cooling. Power draw is minimal and matches standard USB supply levels for safe, quiet operation at a desk.
What the Bundled Filament Refills Enable
Included ABS and PLA refills let you start creating immediately without buying separate spools. Two material choices mean you can test rigidity versus biodegradability on the same pen. No extra software or drivers are needed; creativity begins the moment filament loads.
주요 특징
- Draw vertical or horizontal shapes in the air
- Compatible with ABS and PLA 1.75mm filaments
- Ultra-light 65g body reduces hand fatigue
- Ergonomic grip suits children, designers and hobbyists
- Encourages imagination and 3D art creation
사양
| Brand | Dewang |
|---|---|
| Type | 3D Printing Pen |
| Color | Blue |
| Number of Extruders | 1 |
| Body Material | Plastic |
| Filament Diameter | 1.75mm |
| Max Working Speed | adjustable |
이 상품에 대한 질문
How do I load the 1.75mm filament and start drawing without jamming?
Insert the filament into the rear feed hole until you feel resistance, then press the feed button; the motor will grip and advance it — do not force the strand or the drive gear can strip it
What part will need replacing after regular use?
The 1.75mm ABS or PLA filament refills are the consumable; the nozzle may also wear over time and can be swapped if extrusion becomes uneven
What limits how long I can draw continuously?
The lightweight 65g body has limited heat dissipation, so thermal protection will pause the heater after extended use until the tip cools down
이 진열대의 다른 상품
고객들이 함께 비교한 상품
같은 진열대, 같은 체크아웃 — 코인 8종, 환율 잠금 30분.
